Show simple item record

dc.contributor.authorC. L. Hough
dc.date.accessioned2017-05-08T23:22:14Z
dc.date.available2017-05-08T23:22:14Z
dc.date.copyrightDecember, 1986
dc.date.issued1986
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26414#305_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101013
dc.description.abstractThe effect of back rake angle on a center vacuum bit design was investigated through factorial Analysis of Variance (ANOVA) tests for drilling in shale. Multiple performance criteria: penetration rate, specific energy and torque were used in these tests. Thrust and rotary speed were the controlled variables. Results from ANOVA tests showed that rake angle has a significant effect on penetration rate and torque but not on specific energy. Further tests of means revealed that the 20-deg bit gave the maximum penetration rate although there was no statistical difference among the 15, 20 and 25-deg angles. Tests of means also revealed that the 7-deg bit gives the minimum torque, but is statistically the same as the 15 and 25-deg bits. The results of the test will be useful for design and selection of small-diameter bits for drilling in shale and sand formations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Back Rake Angle on the Performance of Small-Diameter Polycrystalline Diamond Rock Bits: ANOVA Tests
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3231281
dc.journal.fristpage305
dc.journal.lastpage309
dc.identifier.eissn1528-8994
dc.keywordsTorque
dc.keywordsSands
dc.keywordsVacuum
dc.keywordsThrust
dc.keywordsDrilling
dc.keywordsDesign
dc.keywordsDiamonds AND Rocks
dc.treeJournal of Energy Resources Technology:;1986:;volume( 108 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record