Show simple item record

dc.contributor.authorK. K. Yoon
dc.contributor.authorJ. M. Bloom
dc.contributor.authorW. A. Pavinich
dc.contributor.authorH. W. Slager
dc.date.accessioned2017-05-08T23:21:01Z
dc.date.available2017-05-08T23:21:01Z
dc.date.copyrightMay, 1985
dc.date.issued1985
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28256#192_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/100297
dc.description.abstractThe failure assessment diagram approach, an elastic-plastic fracture mechanics procedure based on the J -integral concept, was used in the evaluation of pressure-temperature (P-T) limits for the beltline region of the vessel of a pressurized water reactor. The main objective of this paper is to illustrate the application of an alternate fracture mechanics method for the evaluation of pressure-temperature limits, as allowed by the Code of the Federal Regulation 10 CFR 50 , Appendix G. The evaluation of P-T limits for the beltline region of a pressurized water reactor was based on the following assumptions: • ASME Pressure Vessel and Piping Code, Section III, Appendix G reference flaw • End-of-life fluence level in the beltline region • Longitudinal flaw in the beltline weld • J-resistance material toughness curves obtained from the U.S. Nuclear Regulatory Commission’s heavy section steel technology (HSST) program • Other material properties obtained from the Babcock & Wilcox Integrated Reactor Vessel Material Surveillance Program The maximum allowable pressure levels were calculated at 33 time points along the given reactor bulk coolant temperature history representing the normal operation of a pressurized water reactor. The results of the calculations showed that adequate margins of safety on operating pressure for the critical weld in the beltline of the pressurized water reactor vessel are assured.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleApplication of the Failure Assessment Diagram to the Evaluation of Pressure-Temperature Limits for a Pressurized Water Reactor
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264433
dc.journal.fristpage192
dc.journal.lastpage196
dc.identifier.eissn1528-8978
dc.keywordsTemperature
dc.keywordsPressure
dc.keywordsFailure
dc.keywordsPressurized water reactors
dc.keywordsVessels
dc.keywordsFracture mechanics
dc.keywordsSurveillance
dc.keywordsToughness
dc.keywordsReactor vessels
dc.keywordsSteel
dc.keywordsSafety
dc.keywordsElectrical resistance
dc.keywordsPressure vessels
dc.keywordsCoolants
dc.keywordsMaterials properties
dc.keywordsFluence (Radiation measurement) AND Pipes
dc.treeJournal of Pressure Vessel Technology:;1985:;volume( 107 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record