Show simple item record

dc.contributor.authorW. Szyszkowski
dc.contributor.authorP. G. Glockner
dc.date.accessioned2017-05-08T23:20:58Z
dc.date.available2017-05-08T23:20:58Z
dc.date.copyrightNovember, 1985
dc.date.issued1985
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28261#387_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/100258
dc.description.abstractThere are many applications of thin-walled axisymmetric structures as pressure vessels in which buckle-free in-service behavior can only be guaranteed by reinforcements, such as stringers and girths, which not only raise the weight of the structure but also increase its cost. Buckle-free behavior, however, can also be assured by “correcting” the shape of the pressure vessel by a small amount in the area of impending instability. This paper proposes the use of the theory of inflatable membranes to obtain the shape of a pressure vessel subjected to tension only stress state, whereby the possibility of buckling is excluded. Such a shape will be referred to as the “buckle-free” shape. A set of nonlinear differential equations are derived which are valid for any axisymmetric pressure vessel subjected to axisymmetric loadings. The shape obtained from the solution of the equations is an “extremum” to possible stable shapes under the given loading conditions; i.e., there are other stable shapes, for which the circumferential compressive stiffness of the structure has to be relied upon. A closed-form solution for the set of equations was obtained for the constant pressure loading case. For hydrostatic pressure a numerical procedure is applied. Results on “buckle-free” shapes for typical pressure vessel strucures for these two loading conditions are presented. It is established that the deviation of such shapes from the shapes obtained by present design methods and code specifications is small so that this proposed method and the resulting “corrections’ leading to “buckle-free” inservice behavior should not present an aesthetic problem in design.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDesign for Buckle-Free Shapes in Pressure Vessels
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264472
dc.journal.fristpage387
dc.journal.lastpage393
dc.identifier.eissn1528-8978
dc.keywordsPressure vessels
dc.keywordsDesign
dc.keywordsShapes
dc.keywordsEquations
dc.keywordsMembranes
dc.keywordsNonlinear differential equations
dc.keywordsDesign methodology
dc.keywordsBuckling
dc.keywordsStress
dc.keywordsHydrostatic pressure
dc.keywordsWeight (Mass)
dc.keywordsPressure
dc.keywordsStiffness AND Tension
dc.treeJournal of Pressure Vessel Technology:;1985:;volume( 107 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record