| description abstract | Mass timber panels including cross-laminated timber (CLT), dowel-laminated timber (DLT), and nail-laminated timber (NLT) are used increasingly as floor slabs in mass timber buildings and hybrid timber buildings. The sound insulation performance of bare mass timber structural floors is insufficient due to their lightweight and relatively high bending stiffness. Floating concrete toppings are commonly applied for improved sound insulation performance with an elastic interlayer. The effect of different elastic interlayers and thickness of concrete toppings on improving the impact sound insulation performance was investigated experimentally according to ASTM standards in this study. The results showed that with the same elastic layer, thicker concrete toppings resulted in better impact sound insulation performance with a higher apparent impact insulation class (AIIC). However, by increasing the concrete thickness from 38 to 50 mm and to 70 mm, the improvement of AIIC between two thicknesses was only within 3, and a significant improvement up to 9 was observed with a 100-mm-thick concrete topping. In general, elastic interlayers with lower dynamic stiffness values performed better; however, the performance was product dependent though the apparent dynamic stiffness was measured using the same standard method. Moreover, with the same panel thickness and wood species, a bare DLT floor provided higher AIIC (35) than a bare CLT (21), but each mass timber floor with the same interlayer and floating concrete topping had the same impact sound attenuation performance. The ISO empirical prediction equation overestimated the impact sound attenuation of floating concrete toppings on mass timber floors. | |
