Search
Now showing items 1-6 of 6
Interplay Between Eutectic and Dendritic Growths Dominated by Si Content for Nb-Si-Ti Alloys Via Rapid Solidification
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Rapid solidification techniques such as electron beam additive manufacturing are considered as promising pathways for manufacturing Nb-Si-based alloys for ultra-high-temperature applications. Here, we investigate the ...
Investigation of the Pore Water Pressure of Saturated Warm Frozen Soils Under a Constant Load
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A series of compression experiments was conducted to observe the porewater pressure variations of saturated warm frozen soils over time. The results indicate that saturated warm frozen soils can exhibit excess porewater ...
Experimental Study on the Dynamic Characteristic of Soft Soil under Cyclic Loads
Publisher: American Society of Civil Engineers
Abstract: To study the change law of the dynamic characteristics of soft soil, particularly the inadequate bearing capacity of highway and railway roadbeds induced by traffic loads, the soft soil in Yingkou area was taken as the ...
Study on the Microstructure Evolution and Mechanical Properties of Cu/Cu41Sn11/Cu Solder Joint During High-Temperature Aging
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The paper focused on the changes in microstructure and mechanical properties of the full Cu41Sn11 solder joint (Cu/Cu41Sn11/Cu) during isothermal aging at 420 °C. It was motivated by potential applications of Cu–Sn ...
Creep Behavior of Self-Compacting Rubberized Concrete at Early Age
Publisher: ASCE
Abstract: Self-compacting rubberized concrete (SCRC) is an excellent environment-friendly material that can be applied well in road and bridge engineering. In this study, the tensile and compressive creep performance of SCRC at early ...
Effect of Fin Structure on the Condensation of R-134a, R-1234ze(E), and R-1233zd(E) Outside the Titanium Tubes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In order to test the effect of fin structure on the condensing heat transfer of refrigerants outside the low thermal conductivity tubes, condensation of R-134a, R-1234ze(E), and R-1233zd(E) on two enhanced titanium tubes ...