Search
CSV
RISChaotic Behavior and Feedback Control of Magnetorheological Suspension System With Fractional-Order Derivative
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The fractional differential equations of the single-degree-of-freedom (DOF) quarter vehicle with a magnetorheological (MR) suspension system under the excitation of sine are established, and the numerical solution is ...
A Legendre Polynomials Based Method for Stability Analysis of Milling Processes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a timedomain approach for a semianalytical prediction of stability in milling using the Legendre polynomials. The governing equation of motion of milling processes is expressed as a delaydifferential ...
Numerical Simulations of Freezing Process by Embedding a Cryo-Probe Into Water and Biological Tissue
Publisher: American Society of Mechanical Engineers (ASME)
Abstract: Numerical simulations by finite volume method were performed to investigate the freezing process and growing up of ice ball by embedding a cryo-probe either into a glass tank full of water or biological tissues with and ...
Harmonic Differential Quadrature Method for Surface Location Error Prediction and Machining Parameter Optimization in Milling
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a semianalytical numerical method for surface location error (SLE) prediction in milling processes, governed by a timeperiodic delaydifferential equation (DDE) in statespace form. The time period is ...
On a Numerical Method for Simultaneous Prediction of Stability and Surface Location Error in Low Radial Immersion Milling
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This brief proposes a numerical approach for simultaneous prediction of stability lobe diagrams and surface location error in low radial immersion milling based on the direct integration scheme ...
Numerical Integration Method for Prediction of Milling Stability
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a numerical scheme to predict the milling stability based on the integral equation and numerical integration formulas. First, the milling dynamics taking the regenerative ...
Behavior of Short Lateral Dead Ends on Pipeline Transients: A Lumped Parameter Model and an Analytical Solution
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: By integrating the continuity equation over a short lateral dead end, the effects of a short lateral dead end side branch on pipeline fluid transients can be lumped into a node. The analytical ...
Probabilistic Chloride Penetration Models and Corrosion Initiation Probability of RC Bridge Based on Long-Term Test Data
Publisher: American Society of Civil Engineers
Abstract: Chloride penetration initiates the corrosion of the steel reinforcement and causes the deterioration of an RC bridge in a marine area. This study focuses on the probabilistic models in the chloride penetration process for ...
Stability Analysis of Milling Via the Differential Quadrature Method
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a timedomain semianalytical method for stability analysis of milling in the framework of the differential quadrature method. The governing equation of milling processes taking into account the regenerative ...
Detection and Location of a Partial Blockage in a Pipeline Using Damping of Fluid Transients
Publisher: American Society of Civil Engineers
Abstract: The effects of a partial blockage on pipeline transients are investigated analytically. A partial blockage is simulated using an orifice equation, and the influence of the blockage on the unsteady pipe flow is considered ...