Search
CSV
RISPunching Shear Behavior and Design of an Innovative Connection from Steel Tubular Column to Flat Concrete Slab
Publisher: American Society of Civil Engineers
Abstract: This paper presents the results of an experimental and numerical investigation into the punching shear behavior of a simple and effective method of connection between a steel tubular column and concrete flat slab using ...
Using Local Concentration to Model the Progress of Acoustophoretic Assembly of Microspheres in Planar Standing Waves
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Acoustophoretic assembly uses a standing acoustic field to move dispersed small particles into a geometric pattern. The technique relies on the acoustic radiation force (ARF), which arises from the interaction between the ...
Effects of Mn Content on the Deformation Behavior of Fe–Mn–Al–C TWIP Steels—A Computational Study
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a doubleslip/doubletwin polycrystal plasticity model using finite element solution to investigate the kinetics of deformation twinning of medium manganese (Mn) twinninginduced plasticity (TWIP) steels. ...
Evaluation of the Surface Prognoses of Cyclones and Anticyclones of the JMA and FNOC Models over East Asia and the Western Pacific during the 1983 Mei-Yu Season
Publisher: American Meteorological Society
Abstract: This study compares the systematic errors of 36-h surface cyclone and anticyclone forecasts for two operational numerical weather prediction models over East Asia and the western North Pacific Ocean: the U.S. Navy's ...
A Comparative Study of Flow Boiling in a Microchannel With Piranha Pin Fins
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this paper, we report on the recent development of an advanced microscale heat sink, termed as piranha pin fin (PPF). A 200 خ¼m deep microchannel embedded with PPFs was fabricated and tested. Fluid flow and heat ...
Enhanced Subcooled Flow Boiling Heat Transfer in Microchannel With Piranha Pin Fin
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An experimental study on subcooled flow boiling with engineering fluid HFE-7000 in a microchannel fitted with piranha pin fins (PPFs) is presented. Heat fluxes of up to 735 W/cm2 were achieved and mass fluxes ranged from ...
On the Mechanical Modeling of Functionally Graded Interfacial Zone With a Griffith Crack: Anti-Plane Deformation
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An analytical model is developed for a functionally graded interfacial zone between two dissimilar elastic solids. Based on the fact that an arbitrary curve can be approached by a continuous broken line, the interfacial ...
Numerical Investigation Into the Effects of Motion Parameters on Energy Extraction of the Parallel Foils
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Due to the deficiency of the research on parallel foils, the parallel configuration of foils is concerned and the effects of motion parameters on energy extraction are systematically discussed in the present study. The ...
Performance of a Novel Dynamically Installed Fish Anchor in Calcareous Silt
Publisher: American Society of Civil Engineers
Abstract: Diving upon pullout of an installed anchor leads to an increase in embedment depth and, hence, capacity under operational loadings. It is particularly critical for dynamically installed anchors (DIAs) in calcareous sediments ...
Simultaneous Characterization of Both Coefficients of Thermal Expansion and Thermal Warpages of Flip-Chip Packages With a Cap Using Strain Gauges
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A relatively low-cost and easy-to-use strain gauge measurement is proposed here as an alternative method for simultaneously determining the thermally induced warpages and the coefficients of thermal expansion (CTEs) of the ...