Search
CSV
RISDiscussion: “Machine Tool Chatter: Effect of Surface Slope of Machining Forces During Wave Removing” (Sarnicola, J. F., and Boothroyd, G., 1974, ASME J. Eng. Ind., 96, pp. 1202–1206)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “New Development in the Theory of the Metal-Cutting Process: Part II—The Theory of Chip Formation” (Albrecht, P., 1961, ASME J. Eng. Ind., 83, pp. 557–568)
Publisher: The American Society of Mechanical Engineers (ASME)
An Experimental Investigation of Stick-Slip in Hydrostatic Extrusion Using Wax to Simulate Metals
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes an experimental investigation undertaken to check the explanation advanced by Rice and Iyengar for the violent pressure fluctuations which they observed during hydrostatic ...
An Experimental Investigation of Lubrication in Hydrostatic Extrusion Using Wax as a Model Material
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper describes hydrostatic extrusion experiments in which paraffin wax was extruded, undertaken to test the validity of a theory proposed by Iyengar and Rice concerning the conditions ...
Inhomogeneous Shearing During Continuous Chip Formation
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Metallographic examination of chips cut from a directionally solidified eutectic provided direct evidence of discontinuous shearing in continuous chip formation. The built-in grid of the eutectic ...
Some Effects of Cutting Fluids on Chip Formation in Metal Cutting
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In cutting dry AISI C-1025 steel tubing, with a variety of cutting fluids, and with an internally cooled tool, two distinct equilibria were discerned. Chip temper colors indicate that these ...
Some Effects of Injecting Cutting Fluids Directly Into the Chip-Tool Interface
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An experimental investigation in which SAE 1040 steel was cut orthogonally with fluid being forced directly into the chip-tool interface through a small hole in the rake face of the tool is ...