Abstract: The Fourier transform theory is applied to the analytical determination of the disturbance velocity potential and pressure acting on a two-dimensional plate, in order to reexamine those of ...

Abstract: The cutting mechanism in the honing operation is analyzed theoretically, assuming that one stick corresponds to a single point tool with a long cutting edge. As a result, an evaluating function ...

Abstract: Based on the honing theory developed earlier [12], the nominal depth of cut āi , was found to express the severity of honing conditions when using diamond and CBN sticks. The critical nominal ...

Abstract: The grinding temperature in the surface layer of a ceramic workpiece was measured using an IRP (infrared radiation pyrometer) connected by means of an optical fiber. Two types of optical fiber ...

Abstract: The heat pulses produced by cutting grains in a workpiece were measured using an infrared radiation pyrometer connected by means of an optical fiber. The results obtained were compared with ...

Abstract: The effect of fuel injection timing relative to ignition timing on natural gas direct-injection combustion was studied by using a rapid compression machine (RCM). The ignition timing was fixed ...