Search
CSV
RISDiscussion: “Material Response to Rolling Contact Loading” (Voskamp, A. P., 1985, ASME J. Tribol., 107, pp. 359–364)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “The Influence of Crack Face Friction and Trapped Fluid on Surface Initiated Rolling Contact Fatigue Cracks” (Bower, A. F., 1988, ASME J. Tribol., 110, pp. 704–711)
Publisher: The American Society of Mechanical Engineers (ASME)
A Computerized Expert System for Tribological Failure Diagnosis
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A micro-computer supported, rule-based expert system for failure diagnosis of tribo-components is described. Included is a brief review of AI tools and system organization methods used. The system, ...
Erratum: “Rolling Bearing Life Prediction. Corrections for Material and Operating Conditions. Part I: General Model and Basic Life” (Journal of Tribology, 1988, 110, pp. 2–5)
Publisher: The American Society of Mechanical Engineers (ASME)
Rolling Bearing Life Prediction. Corrections for Material and Operating Conditions. Part II: The Correction Factors
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Computer based rolling bearing analysis programs exist which provide models for load and stress distribution, EHD conditions, heat balance and fatigue life prediction for rolling bearings and ...
Rolling Bearing Life Prediction. Corrections for Material and Operating Conditions. Part I: General Model and Basic Life
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Computer based rolling bearing analysis programs exist which provide models for load and stress distribution, EHD conditions, heat balance and fatigue life prediction for rolling bearings and ...
Closure to “Discussions of ‘Simplified Contact Fatigue Life Prediction Model—Part II: New Model’” (1992, ASME J. Tribol., 114, pp. 220–222)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Piezoviscous-Rigid Rolling and Sliding Traction Forces, Application: The Rolling Element–Cage Pocket Contact” (Houpert, L., 1987, ASME J. Tribol., 109, pp. 363–370)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Elastic Stresses Below Asperities in Lubricated Contacts” (Ioannides, E., and Kuijpers, J. C., 1986, ASME J. Tribol., 108, pp. 394–400)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Interpretations of the Thickness of Lubricant Films in Rolling Contact—1. Examination of Measurements Obtained by X-Rays” (Kannel, J. W., and Bell, J. C., 1971, ASME J. Lubr. Technol., 93, pp. 478–484)
Publisher: The American Society of Mechanical Engineers (ASME)