Abstract: Ball milled SnCoC composites are an attractive commercial anode material to conventional graphite due to their higher specific capacity and low temperature performance. The effect of ball milling time on the structure and ...

Abstract: A thermal hydraulic model is developed for a solid pin-fueled fluoride-salt-cooled small modular advanced high temperature reactor (SmAHTR). This preconceptual SmAHTR was developed by the Oak Ridge National Laboratory ...

Abstract: This paper presents a multiple flow-regime model for pressure drop during condensation of refrigerant R134a in horizontal microchannels. Condensation pressure drops measured in two circular and ...

Abstract: Some commercial units and industries need more amount of cooling than the power such as cold storage, shopping complex, etc. In this work, a new cooling cogeneration cycle (Srinivas cycle) has been proposed and solved to generate more cooling...

Abstract: Condensation pressure drops and heat transfer coefficients for refrigerant R134a flowing through rectangular microchannels with hydraulic diameters ranging from 100 μm to 200 μm are measured in ...

Abstract: One of the fundamental unsolved problems in geometric design of mechanical solids has been the lack of a proper notion of family or class. Numerous heuristic and often incompatible definitions ...

Abstract: Life cycle assessment (LCA) is used to estimate a product’s environmental impact. Using LCA during the earlier stages of design may produce erroneous results since information available on the ...

Abstract: Adsorption heat pumps and chillers (ADHPCs) can utilize solar or waste heat to provide space conditioning, process heating or cooling, or energy storage. In these devices, intraparticle diffusion ...

Abstract: In the context of evacuation planning at a strategic level, an efficient model is proposed to augment network capacity under a budget constraint so as to enhance operational performance under a security threat. Contraflow ...