Abstract: The stability lobe diagrams predicted using the tool frequency response function (FRF) at the idle state usually have discrepancies compared with the actual stability cutting boundary. These discrepancies can be attributed ...

Abstract: Currently, it still lacks the controlled studies which compare differences in the machinability between the TA15 alloy and network-structured TiBw/TA15 composites, which is not conducive to promoting the design and practical ...

Abstract: In aviation and navigation, complicated parts are milled with high-speed low-feed-per-tooth milling to decrease tool vibration for high quality. Because the nonlinearity of the cutting force coefficient (CFC) is more evident ...

Abstract: Uneven distribution of machining-induced residual stresses (MIRS) caused by dynamic cutting conditions and material internal properties has a significant impact on fatigue resistance, stress corrosion resistance, and ...

Abstract: A thermal model estimating workpiece temperature in orthogonal turnmilling compound machining for the case with noneccentricity between rotation axes of workpiece and tool has been established in this paper. Milling tool ...

Abstract: During the micromachining processes of particle-reinforced metal matrix composites (PMMCs), matrix-particle interface failure plays an important role in the cutting mechanism. This paper presents a novel analytical model ...

Abstract: The traditional stability analysis by only considering cutting depth-spindle speed lobe diagram is appropriate for parameters optimization and efficiency improvement of the five-axis ball-end milling. However due to the ...

Abstract: The white layer formed in machining has significant impacts on the friction property, fatigue resistance, and service life of products. This paper presents an analytical model for white layer prediction in orthogonal cutting ...

Abstract: In the tool orientation planning for five-axis sculptured surface machining, the geometrical constraints are usually considered. Actually, the effect of nongeometrical constraints on tool orientation planning is also ...

Abstract: When machining narrow grooves, corners, and other complex cavities with trochoidal milling, the irrationally large trochoidal step usually leads to chatter, while the conservative trochoidal step constrains the machining ...