Search
Now showing items 1-4 of 4
A Test Facility for the Measurement of Torques at the Shaft to Seal Interface in Brush Seals
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An important factor in the performance of brush seals for a wide range of gas turbine applications is the rate of wear at the seal to shaft interface, which is dependent on the contact ...
A Numerical Study of Laminar 90-Degree Bend Duct Flow With Different Discretization Schemes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Three different discretization schemes were used to study the flow in a 90-degree bend square duct. The numerical method consists of a general curvilinear coordinate formulation of the governing ...
An Iterative CFD and Mechanical Brush Seal Model and Comparison With Experimental Results
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The position of the bristles within a brush seal is dictated by the pressure distribution within the seal, which is itself influenced by the position of the bristle matrix. In order to predict ...
Detailed Experimental Studies of Flow in Large Scale Brush Seal Model and a Comparison With CFD Predictions
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A five times scale model of an engine brush seal has been manufactured. The bristle stiffness and pressure were chosen to satisfy close similarity of the relevant non-dimensional parameters, ...