Abstract: , as they appear in literature. This work is intended to be of use to engineers engaged in research and practice alike. Two new contributors are welcomed to this effort: Professor G. Boothroyd, University of Massachusetts, who has...

Abstract: The effect of the work surface slope, or the rate of change of undeformed chip thickness, on the shear angle in metal cutting is studied experimentally. It is shown that the results of ...

Abstract: A theoretical study is made of the orientations in which small parts will naturally feed in a vibratory-bowl feeder. The results are applied to regular prismatic part shapes and are tested ...

Abstract: Examination is made of similar conditions concerning transport phenomena in the conveyance of particulate suspensions by gases. The paper, in large part, concerns conveyance in straight ducts. ...

Abstract: The results of experiments are described where the energy loss per cycle occurring at a flat metallic interface subjected to oscillating tangential loads is measured. The effects of the magnitudes ...

Abstract: A statistical analysis of the performance of a vee cutout orienting device used in a vibratory bowl feeder is presented. The results of experimental tests are described and compared with the ...

Abstract: A review is presented concerning the mechanics of the metal-cutting process where a continuous chip is produced with the absence of a built-up edge on the tool face. It is shown that previous ...