Search
CSV
RISDesign Method for Turbomachine Blades With Finite Thickness by the Circulation Method
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a procedure to extend a recently developed three-dimensional inverse method for infinitely thin blades to handle blades with finite thickness. In this inverse method, the ...
Design of Turbomachinery Blading in Transonic Flows by the Circulation Method
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The newly developed three-dimensional design technique for turbomachinery blading based on the circulation method has been successfully extended into the transonic flow regime. The main task ...
A Fully Three-Dimensional Inverse Method for Turbomachinery Blading in Transonic Flows
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a procedure to extend a recently developed fully three-dimensional inverse method for highly loaded turbomachine blades into the transonic-flow regime. In this inverse method, ...
Re-Entrant Jet Modeling of Partial Cavity Flow on Two-Dimensional Hydrofoils
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A potential based panel method is developed to predict the partial cavity flow on two-dimensional hydrofoil sections. The Dirichlet type dynamic boundary condition on the cavity surface and the ...
Re-Entrant Jet Modeling of Partial Cavity Flow on Three-Dimensional Hydrofoils
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A potential-based lower-order surface panel method is developed to calculate the flow around a three-dimensional hydrofoil with an attached sheet cavity the leading edge. A Dirichlet type dynamic ...
Geometry of Sand Ripples due to Combined Wave-Current Flows
Publisher: American Society of Civil Engineers
Abstract: Laboratory data on sand ripple spacing due to combined wave-current motion are collected to examine the validity of the empirical formula proposed by Tanaka and Shuto (1984). Data from Gray et al. (1991) and from Van Rijn ...
Distributed Flow Estimation for Autonomous Underwater Robots Using Proper Orthogonal Decomposition-Based Model Reduction
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Flow estimation plays an important role in the control and navigation of autonomous underwater robots. This paper presents a novel flow estimation approach that assimilates distributed pressure measurements through coalescing ...
Multiobjective Optimization of the Heating Process for Forging Automotive Crankshaft
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents potential approaches that increase the energy efficiency of an inline induction heating system for forging of an automotive crankshaft. Both heat loss reduction and optimization of process parameters ...
Distributed Flow Estimation for Autonomous Underwater Robots Using Proper Orthogonal Decomposition-Based Model Reduction
Publisher: American Society of Mechanical Engineers (ASME)
Abstract: Flow estimation plays an important role in the control and navigation of autonomous underwater robots. This paper presents a novel flow estimation approach that assimilates distributed pressure measurements through coalescing ...
Influence of Low-Frequency Vertical Vibration on Walking Locomotion
Publisher: American Society of Civil Engineers
Abstract: Walking locomotion has been a subject of studies in diverse research fields, such as computer, medical, and sport sciences, biomechanics, and robotics, resulting in improved understanding of underlying body motion and gait ...