Abstract: Based on two models of material removal in ultrasonic machining, developed in an earlier work, conditions for optimum abrasive life for the objective functions of minimum cost per unit volume ...

Abstract: The results of a series of short-run cutting tests conducted with “Hi-jet” system using four common commercially available fluids are presented. The possibility of using these tests for on-the-spot ...

Abstract: An experimental investigation in which SAE 1040 steel was cut orthogonally with fluid being forced directly into the chip-tool interface through a small hole in the rake face of the tool is ...

Abstract: Recently developed sintered cast iron products from cast iron swarf powder have been examined for its application to plain bearing. In this paper, the mechanical properties related to bearing ...