Search
Now showing items 1-10 of 11
Measurements in Two-Dimensional Plumes in Crossflow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The mean-flow and turbulent properties of two-dimensional buoyant jets discharged vertically upward into a crossflowing ambient have been measured in a hydraulic flume, using laser velocimetry and ...
Studies on Two-Dimensional Curved Nonbuoyant Jets in Cross Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An experimental study of two-dimensional, curved, heated (but essentially non-buoyant) jets is reported. The experiments were conducted in a hydraulic flume in which a curved jet was produced ...
Visualization of the Wing-Tip Vortex in Temporal and Spatial Pressure Gradients
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The evolution of the longitudinal vortex in the near field of a rectangular wing has been visualized using smoke and laser light sheet. The smoke photographs have been used to obtain qualitative ...
Performance of Conical Diffusers With Annular Injection at Inlet
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Data on the gross performance of conical diffusers subjected to annular secondary injection at inlet are reported. Tests indicate that the improvement in diffuser performance is significant even ...
A Modified Entrainment Theory for the Prediction of Turbulent Boundary Layer Growth in Adverse Pressure Gradients
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: An approach based on the “entrainment” theory is presented as a tool for the prediction of turbulent boundary layer growth in adverse pressure gradients. The rate of entrainment of free-stream ...
Turbulence Measurements in Boundary Layers Along Mildly Curved Surfaces
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents results of turbulence measurements in boundary layers over surfaces of mild longitudinal curvature. The study indicates that convex wall curvature decreases both the length ...
Calibration of a Heat Flux Gage for Skin Friction Measurement
Publisher: The American Society of Mechanical Engineers (ASME)
LDA Measurements in Plane Turbulent Jets
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Measurements on the mean and most of the significant turbulent properties of plane isothermal and heated (but essentially “nonbouyant”) jets are reported. The velocity measurements were made using ...
Measurements in Vertical Plane Turbulent Plumes
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Mean-flow and turbulence measurements have been obtained in two-dimensional vertical turbulent plumes in a nominally still ambient. The plumes were generated by injecting hot water vertically ...
Correcting for Response Lag in Unsteady Pressure Measurements in Water
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: There is not much information available on the use of diaphragm-type pressure transducers for the measurement of unsteady pressures in liquids. A procedure for measuring the dynamic response of ...
CSV
RIS