Search
CSV
RISFree Abrasive Machining in Slicing Brittle Materials With Wiresaw
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Wiresaw has emerged as a leading technology in wafer preparation for microelectronics fabrication, especially in slicing large silicon wafers (diameter≥300 mm) for both microelectronic and photovoltaic ...
Intelligent Sliding Mode Control of Cutting Force During Single-Point Turning Operations
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A novel intelligent control architecture has been developed to regulate cutting forces during single-point turning operations. A self-adapting Sliding Mode Controller (SMC) accounts for parameter ...
Warping Analysis in Laminated Object Manufacturing Process
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This study presents an analysis of warping that occurs in the laminated object manufacturing process. Based on the study of thermal-mechanical behavior of the adhesive and its effect on the ...
Practical Airgap Prediction for Offshore Structures
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Two new methods are proposed to predict airgap demand. Airgap demand is the maximum expected increase in the water surface elevation caused incident waves interacting with an offshore structure. ...
Transient Vibration Analysis of a Pinned Beam With Transverse Magnetic Fields and Thermal Loads
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The research investigates the transient vibrations of a pinned beam with transverse magnetic fields and thermal loads. The equation of motion is derived by the Hamilton’s principal, and the ...
Performance Characteristics of a Centrifugal Pump Impeller With Running Tip Clearance Pumping Solid-Liquid Mixtures
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents extensive results on the performance of an unshrouded centrifugal pump impeller handling solid-liquid mixtures. The effect of the clearance between the impeller tip and the ...
Control of Volumetric Flow-Rate of Ball Valve Using V-Port
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The control of volume flow rate in a ball valve is very important when a ball valve is utilized in a piping system. It is difficult to linearly control the flow rate in a ball valve ...
Elastic-Plastic Finite Element Analysis of Partial Slip Rolling Contact
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The finite element model with the implementation of a robust cyclic plasticity theory was used to simulate the elastic-plastic stresses for the partial slip (stick-slip) line rolling contact. ...
Experimental Nonlinear Dynamics of a Shape Memory Alloy Wire Bundle Actuator
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: In this paper, the nonlinear dynamics of a new Shape Memory Alloy (SMA) actuator that possesses impressive payload lifting capabilities are presented. This actuator consists of 48 SMA wires ...
Computationally Efficient Micromechanical Models for Woven Fabric Composite Elastic Moduli
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents two newly developed micromechanical models for the analysis of plain weave fabric composites. Both models utilize the representative volume cell approach. The representative ...