Abstract: Cutting tools of sufficient strength against failure by brittle fracture or loss of “form stability” through rise of interface temperatures, still continue to fail by a process of “wear,” which ...

Abstract: The exacting demands for producing accurate gears make it necessary to determine the cutting forces coming on the hob-shaft which is the weakest element subjected to severe bending and torsion. ...

Abstract: For machining with cemented carbides and ceramics, a quantitative assessment of tool failure at the flank for establishing “limit criterion” is necessary. The arbitrarily chosen flank wear limit ...

Abstract: A considerable amount of thrust force during drilling is due to the cutting action at the chisel edge of drills. This is in turn due to large values of negative rake angle along with a ...

Abstract: This paper reports an experimental investigation of rotordynamic forces in a whirling axial flow inducer under the influence of cavitation at various flow coefficients. The results show the ...