Show simple item record

contributor authorM. Senator
date accessioned2017-05-08T23:10:36Z
date available2017-05-08T23:10:36Z
date copyrightAugust, 1981
date issued1981
identifier issn0148-0731
identifier otherJBENDY-25678#151_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/94269
description abstractA theory is developed to explain why racing shell crews use sliding seats and shorter-than-necessary stroke intervals, two features that tend to waste energy in a highly competitive, power-limited situation. The theory shows that sliding seats are used because they allow the crew to move the oar blades fast enough during the stroke to transfer all available power to the water. Shorter-than-necessary stroke intervals are used to minimize the sum of the power dissipated in developing thrust, which decreases with the relative length of the stroke interval, and the power dissipated in hull drag due to fluctuations about average velocity, which increases with the relative length of the stroke interval. Using representative dimensions and masses, a typical value of average velocity for a race, and independently estimated values of drag and thrust coefficients, the theory predicts an optimum stroke fraction of 0.400, an optimum stroke rate of 45 per min, and an accountable power of 0.46 hp/man for an eight-oar racing shell, values that agree remarkably well with those used under competitive racing conditions. The theory indicates that using wider-bladed oars might improve performance; the theory also supports a suggestion made to the writer by R. A. Swanson that crossing the oars over the shell would improve performance.
publisherThe American Society of Mechanical Engineers (ASME)
titleWhy Sliding Seats and Short Stroke Intervals are Used for Racing Shells
typeJournal Paper
journal volume103
journal issue3
journal titleJournal of Biomechanical Engineering
identifier doi10.1115/1.3138271
journal fristpage151
journal lastpage159
identifier eissn1528-8951
keywordsShells
keywordsDrag (Fluid dynamics)
keywordsThrust
keywordsFluctuations (Physics)
keywordsBlades
keywordsWater
keywordsHull AND Dimensions
treeJournal of Biomechanical Engineering:;1981:;volume( 103 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record