Show simple item record

contributor authorD. J. Glaser
contributor authorC. L. Nachtigal
date accessioned2017-05-08T23:07:11Z
date available2017-05-08T23:07:11Z
date copyrightAugust, 1979
date issued1979
identifier issn1087-1357
identifier otherJMSEFK-27680#362_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/92391
description abstractA major problem in the active control of the boring process is developing a practical method of providing small-amplitude tool-tip positioning. The main thrust of the underlying research work is the design, development and evaluation of a new actuation concept for active control of the boring operation. The actuation concept was implemented using a special boring bar with two internal longitudinal hydraulic chambers. A pressure difference between these two chambers provides the driving force to create the desired tool-tip motion. Using a measure of the dynamic cutting force, the controlled boring bar system was successful in making improvements over the uncontrolled boring bar’s cutting performance in terms of regenerative chatter control. The cutting tests used in this thesis were plunge cuts in mild steel. The controlled level of improvement was smaller than was anticipated. The problem was considered not a fault of the actuation scheme, but a result of a non-optimal combination of the servovalve, measurement system and controller. Further work in these areas should yield considerably improved results using the new actuation concept.
publisherThe American Society of Mechanical Engineers (ASME)
titleDevelopment of a Hydraulic Chambered, Actively Controlled Boring Bar
typeJournal Paper
journal volume101
journal issue3
journal titleJournal of Manufacturing Science and Engineering
identifier doi10.1115/1.3439519
journal fristpage362
journal lastpage368
identifier eissn1528-8935
keywordsForce
keywordsPressure
keywordsSteel
keywordsControl equipment
keywordsMotion
keywordsThrust
keywordsDesign
keywordsChatter
keywordsCutting AND Measurement systems
treeJournal of Manufacturing Science and Engineering:;1979:;volume( 101 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record