| contributor author | D. M. Turley | |
| date accessioned | 2017-05-08T22:58:44Z | |
| date available | 2017-05-08T22:58:44Z | |
| date copyright | January, 1975 | |
| date issued | 1975 | |
| identifier issn | 0094-4289 | |
| identifier other | JEMTA8-26839#21_1.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/87547 | |
| description abstract | The surface finishes produced by taper reaming of holes in a composite structure of aluminum alloy and ultra-high strength steel are examined for both dry and lubricated cutting conditions. In dry reaming cutting occurred under built-up-edge (BUE) conditions whereas when a mineral cutting oil was used no significant BUE was formed. Reaming under the latter conditions resulted in a more undulating steel surface finish but a much smoother surface finish for the aluminum alloy. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Surface Finishes Produced by Tungsten Carbide Taper Pin Reamers | |
| type | Journal Paper | |
| journal volume | 97 | |
| journal issue | 1 | |
| journal title | Journal of Engineering Materials and Technology | |
| identifier doi | 10.1115/1.3443255 | |
| journal fristpage | 21 | |
| journal lastpage | 24 | |
| identifier eissn | 1528-8889 | |
| keywords | Finishes | |
| keywords | Tungsten | |
| keywords | Cutting | |
| keywords | Steel | |
| keywords | Aluminum alloys AND Composite materials | |
| tree | Journal of Engineering Materials and Technology:;1975:;volume( 097 ):;issue: 001 | |
| contenttype | Fulltext | |
