Show simple item record

contributor authorDimos Polyzois
contributor authorLloyd J. Guillory, Jr.
date accessioned2017-05-08T22:35:24Z
date available2017-05-08T22:35:24Z
date copyrightJanuary 1991
date issued1991
identifier other%28asce%290733-9399%281991%29117%3A1%28184%29.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/83186
description abstractCold‐formed steel sections used as purlins in low‐rise industrial steel buildings are usually attached along one flange to the roofing material and are often supported along their span by sag rods. Under uplift loading, these sections rotate about the points of attachment to the roofing material, resulting in out‐of‐plane bending of the web. This out‐of‐plane bending of the web gives rise to stress variations that could influence the postbuckling capacity of the sections. Current specifications assume that cross‐sectional properties of cold‐formed members remain constant until failure occurs. The present paper describes the development of a numerical model, based on the finite strip method, which incorporates many factors, such as shear rigidity and rotational stiffness of roofing material, as well as the absence/presence of sag rods, which influence the behavior of cold‐formed steel purlins. Results indicate that the degree of out‐of‐plane bending of the web depends on the relative magnitude of these factors. Analysis of cold‐formed steel purlins was carried out efficiently and economically using the finite strip method.
publisherAmerican Society of Civil Engineers
titleFinite Strip Method for Analysis of Cold‐Formed Purlins
typeJournal Paper
journal volume117
journal issue1
journal titleJournal of Engineering Mechanics
identifier doi10.1061/(ASCE)0733-9399(1991)117:1(184)
treeJournal of Engineering Mechanics:;1991:;Volume ( 117 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record