Evaluation of Contaminant Resuspension Potential during Cap Placement at Two Dissimilar Sites

Abstract

Capping is a common remediation technology for the containment/stabilization of contaminated sediments. During capping activities, clean material is commonly released from a barge at the water surface and falls through the water column to the sediment surface, providing an uncontaminated surface sediment layer. Little information exists on the potential release of in situ contaminated sediments during and after capping operations. This paper focuses on the measured release of contaminants during capping events at Boston Harbor, Mass. (confined aquatic disposal cells for contaminated sediment) and Eagle Harbor, Wash. (creosote-contaminated sediment from a wood treating facility). The water column was sampled during capping events to evaluate whether cap placement resulted in the release of polycyclic aromatic hydrocarbons (PAH)- or polychlorinated biphenyls (PCB)-contaminated sediments at Boston Harbor, or PAH-contaminated sediments at Eagle Harbor. Though results at both sites indicated some contaminant resuspension during capping operations, in general contaminant resuspension was relatively low for all capping events. PCB and PAH concentrations for most samples were in the low