| contributor author | Jonathan W. Martin | |
| contributor author | Edward Embree | |
| date accessioned | 2017-05-08T21:16:33Z | |
| date available | 2017-05-08T21:16:33Z | |
| date copyright | August 1989 | |
| date issued | 1989 | |
| identifier other | %28asce%290899-1561%281989%291%3A3%28151%29.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/45217 | |
| description abstract | Over one billion square feet of EPDM (ethylene‐propylene‐diene terpolymer) are installed annually. The most frequently cited failure mode for this system is the failure of field‐formed seams. Talc‐like particulates introduced during manufacture may be one of the causes of seam failure, since these particulates could block the formation of adhesive bonds. To test this hypothesis, the T‐peel strength of butyl‐adhered, EPDM joints is ascertained as a function of contamination level and cure time. It is found that the Gompertz model fits the data quite well and that at high contamination levels, the Gompertz model predicts that the maximum strength of a joint could be as little as one‐half that of a clean joint and the joints failed adhesively. The maximum achievable strength is in well‐cleaned joints that always failed cohesively. These results emphasize the importance of surface cleanness and the need for standards and guidelines to assure the performance of joints. | |
| publisher | American Society of Civil Engineers | |
| title | Effect of Contaminants and Cure Time on EPDM Single‐Ply Joint Strength | |
| type | Journal Paper | |
| journal volume | 1 | |
| journal issue | 3 | |
| journal title | Journal of Materials in Civil Engineering | |
| identifier doi | 10.1061/(ASCE)0899-1561(1989)1:3(151) | |
| tree | Journal of Materials in Civil Engineering:;1989:;Volume ( 001 ):;issue: 003 | |
| contenttype | Fulltext | |