Show simple item record

contributor authorLee, H. T.
contributor authorHo, C. Y.
contributor authorLee, C. C.
date accessioned2022-05-08T09:06:59Z
date available2022-05-08T09:06:59Z
date copyright10/6/2021 12:00:00 AM
date issued2021
identifier issn1043-7398
identifier otherep_144_04_041001.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4284745
description abstractEffects of Ag content (0 ∼ 3 wt%) in Sn-xAgCu0.7 solders on microstructure characteristics and low cycling fatigue at different temperature conditions are overall investigated. To increase Ag content, the solidus points 228.8 °C of Sn-Cu0.7 gradually decrease to 218.5 °C and temperature range of solid–liquid coexistence phase reduces at the same time. The Sn-Cu0.7 matrix consisted of small particles of Cu6Sn5 within β-Sn equiaxial grains and did not significantly influence solder hardness. Moreover, much intermetallic compound of plate-like Ag3Sn and rod-like Cu6Sn5 existed in Sn-xAgCu0.7 solders enables to enhance the hardness due to dense network of Ag3Sn precipitation and near eutectic point. As a result of plastic displacement decreases with higher Ag additions, better fatigue lifetime could be achieved at Ag content to 1.5 wt%. Besides, crack stemmed from thicker intermetallic compounds (IMC) layer in Sn-3.0Ag-Cu0.7 solder interface will decrease fatigue performance especially for 80 °C and 120 °C.
publisherThe American Society of Mechanical Engineers (ASME)
titleOptimized Design of Various Ag Decorated Sn-xAg-Cu0.7 Solder Bump on Cycling Fatigue Reliability for Wafer-Level Chip Scale Packaging
typeJournal Paper
journal volume144
journal issue4
journal titleJournal of Electronic Packaging
identifier doi10.1115/1.4052075
journal fristpage41001-1
journal lastpage41001-7
page7
treeJournal of Electronic Packaging:;2021:;volume( 144 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record