Show simple item record

contributor authorLuo, Jingjing
contributor authorBrillert, Dieter
date accessioned2022-02-05T22:19:22Z
date available2022-02-05T22:19:22Z
date copyright2/8/2021 12:00:00 AM
date issued2021
identifier issn0742-4795
identifier othergtp_143_03_031005.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4277339
description abstractDry gas–lubricated noncontacting mechanical seals (DGSs), most commonly found in centrifugal compressors, prevent the process of gas flow into the atmosphere. Especially when high speed is combined with high pressure, DGS is the preferred choice over other sealing alternatives. Even though the noncontacting seal is proved reliable, the ultrathin gas film can still lead to a host of potential problems due to possible contact. In order to investigate the flow field in the sealing gap and to facilitate the numerical prediction of the seal performance, a dedicated test facility is developed to carry out the measurement of key parameters in the gas film. Gas in the sealing film varies according to the seal inlet pressure, and the thickness of gas film depends on this fluctuated pressure. In this paper, the test facility, measurement methods, and the first results of static pressure measurements in the sealing gap of the DGS obtained in the described test facility are presented. An industry DGS with three-dimensional grooves on the surface of the rotating ring, where experimental investigations take place, is used. The static pressure in the gas film is measured, up to 20 bar and 8100 rpm, by several high-frequency ultraminiature pressure transducers embedded into the stationary ring. The experimental results are discussed and compared with the numerical model programed in matlab (Luo, J., Dohmen, H. J., and Benra, F. K., 2018, “Coupled Thermal-Structural-Fluid Numerical Analysis of Gas Lubricated Mechanical Seals,” ASME Paper No. GT2018-75458), the characteristic and magnitude of which have a good agreement with the numerical simulations. It suggests the feasibility of measuring pressure profiles of the standard industry DGS under pressurized dynamic operating conditions without altering the key components of the seal, and thereby affecting the seal performance.
publisherThe American Society of Mechanical Engineers (ASME)
titleExperimental Investigations on the Pressure Fluctuations in the Sealing Gap of Dry Gas Seals With Embedded Pressure Sensors
typeJournal Paper
journal volume143
journal issue3
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.4049662
journal fristpage031005-1
journal lastpage031005-7
page7
treeJournal of Engineering for Gas Turbines and Power:;2021:;volume( 143 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record