Show simple item record

contributor authorKadivar, Mohammadreza
contributor authorKadivar, Mohammadali
contributor authorDaneshi, Amir
date accessioned2022-02-04T23:00:08Z
date available2022-02-04T23:00:08Z
date copyright8/1/2020 12:00:00 AM
date issued2020
identifier issn1948-5085
identifier othertsea_12_4_041009.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4275884
description abstractGrinding is a promising machining method for finishing workpieces that need a smooth surface with tight tolerances. Due to the high thermal energy generated in the grinding zone, an accurate prediction of workpiece temperature plays a crucial role in the design and optimization of the grinding process. Finite difference method (FDM) is used for simulating the temperature distribution in a workpiece subjected to shallow grinding using a DuFort–Frankel explicit scheme. Moreover, two simple methods, one for modeling the effect of material removal in shallow grinding and the other for calculating the heat partition, are presented. A semi-empirical correlation of cooling jet is applied to calculate the convection heat transfer coefficient (CHTC) over the grinding surface. Experiments were carried out to verify the simulation results, and a good agreement was observed between the simulation and experimental data. An analysis of the results indicated that the misestimation of workpiece temperature could occur when the effect of the material removal rate is not considered in the simulation. The simulation results showed that the heat flux flow is one-dimensional for a high Peclet number, while a two-dimensional heat flux flow prevails for a low Peclet number. The results revealed that reducing the Peclet number and extending the depth of cut increase the heat partition. The study of wet grinding demonstrated that, for efficient cooling, the coolant should be applied directly to the contact zone. Moreover, using water-based emulsion as a coolant was more effective than palm and sunflower oils.
publisherThe American Society of Mechanical Engineers (ASME)
titleA Numerical Model for Heat Transfer in Dry and Wet Grinding Based on the Finite Difference Method and Jet Cooling
typeJournal Paper
journal volume12
journal issue4
journal titleJournal of Thermal Science and Engineering Applications
identifier doi10.1115/1.4045676
journal fristpage041009-1
journal lastpage041009-14
page14
treeJournal of Thermal Science and Engineering Applications:;2020:;volume( 012 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record