| description abstract | This research sought to develop a fabricable prosthetic liner that could be fabricable, intuitive, and a cost-effective means of providing advanced prosthetics in developing settings. An affordable ethyl-vinyl-acetate roll-on (AERO) liner for permitting a total surface bearing suction socket design was created and provided to a single participant for in vivo outcome measurements. The liner was fabricated from locally produced low-density ethyl-vinyl-acetate (EVA) foam. A liner fabrication process was developed and described, and one participant was provided 3 mm and 6 mm AERO liner variants for outcome evaluations. Six-minute walk test, residual limb temperature, and socket comfort score (SCS) while in AERO liner were collected. Thirty-day step counts of AERO liner with prosthesis and thermoplastic elastomer (TPE) liner with prosthesis were collected. The results of in vivo evaluations indicate increased speed, slightly higher residuum temperature, and increased comfort of the 6 mm AERO liner. Pedometer tallied step counts for the AERO liner and TPE liner prostheses were similar. The 6 mm AERO liner provided the best comfort and function of the two thicknesses in liners, and step count data indicated that the volume of patient activity was similar to when wearing the TPE liner prosthesis. Roll-on fabricable low-cost liners offer an affordable means of providing total surface bearing suction prostheses for resource limited environments (RLE). A prosthetist or technician can use the existing skills and lab to create liners. | |
