Show simple item record

contributor authorStefano Mungiguerra
contributor authorGiuseppe D. Di Martino
contributor authorGennaro Zuppardi
date accessioned2022-01-30T20:04:59Z
date available2022-01-30T20:04:59Z
date issued2020
identifier other%28ASCE%29AS.1943-5525.0001114.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4266484
description abstractWith a view to designing tests in the arc wind tunnel small planetary entry simulator (SPES) at the Department of Industrial Engineering of the University of Naples “Federico II” on specimens of ultra-high-temperature ceramic (UHTC) materials, computer simulations have been carried out in order to get information about the test conditions, i.e., electrical power supplied to the torch, the nozzle area ratio (exit area/throat area), and the specimen geometry, to avoid expensive and time-consuming experimental characterization. Computations have been carried out both by a computation fluid-dynamics (CFD) and a direct simulation Monte Carlo (DSMC) code. The computations provided important quantitative information about flow field for velocity, temperature, gas composition, etc., and about heat flux and pressure on the specimen. The present computations allowed the authors to define the capabilities of SPES to perform tests on UHTC specimens, identifying a range of potential applications. Computed values of heat flux have been also compared with preliminary measurements performed by means of a copper slug calorimeter. Because of the evident effect of surface catalytic level on the experimental measurements, an experimental/computational procedure has been used to estimate the recombination efficiencies of oxygen and nitrogen on the calorimeter surface. The definition of this procedure is aimed at a future evaluation of surface catalyticity of UHTC specimens. At the conditions tested in the present paper, the procedure indicates that oxygen catalytic effect is higher than that of nitrogen, which is in agreement with what is reported in the literature.
publisherASCE
titleComputational Evaluation of Aero-Thermodynamic Loads and Effect of Catalyticity in an Arc-Jet Wind Tunnel
typeJournal Paper
journal volume33
journal issue3
journal titleJournal of Aerospace Engineering
identifier doi10.1061/(ASCE)AS.1943-5525.0001114
page04020005
treeJournal of Aerospace Engineering:;2020:;Volume ( 033 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record