Show simple item record

contributor authorDuong, C. N.
date accessioned2019-06-08T09:27:58Z
date available2019-06-08T09:27:58Z
date copyright3/5/2019 12:00:00 AM
date issued2019
identifier issn0021-8936
identifier otherjam_86_5_051006.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4257455
description abstractModeling the interface between two adherents in a co-cured composite joint for a delamination analysis is always a challenge since properties and thickness of the material forming the interface are not clearly defined or well characterized. In a conventional finite element (FE) analysis using virtual crack closure technique (VCCT) based on a linear elastic fracture mechanics (LEFM) theory, adherents are assigned to share the same common nodes along their intact interface. On the other hand, an FE analysis using cohesive elements or analytical methods based on an adhesive joint model for a delamination analysis of a co-cured joint will require modeling of the interface as well as the appropriate selection of its thickness and properties. The purpose of this paper is to establish the applicability and limitation of the adhesive joint model for a delamination analysis of a co-cured composite joint. In particular, it will show that when certain requirements are met, the strain energy release rates (SERR) become independent or nearly independent of the adhesive stiffness and thickness, and thus, SERR of an adhesive joint will be the same as that for a co-cured joint. These requirements are determined from a theoretical consideration, and they can be expressed explicitly in terms of joint characteristic (or load transfer) lengths and joint physical lengths. The established requirements are further validated by numerical results for various cracked joint geometries. Finally, implication of a mode ratio obtained by the proposed adhesive joint model for a corresponding delamination crack is discussed.
publisherThe American Society of Mechanical Engineers (ASME)
titleAdhesive Joint Model for Delamination Analysis of a Co-Cured Composite Joint: Applicability and Limitation
typeJournal Paper
journal volume86
journal issue5
journal titleJournal of Applied Mechanics
identifier doi10.1115/1.4042893
journal fristpage51006
journal lastpage051006-11
treeJournal of Applied Mechanics:;2019:;volume( 086 ):;issue: 005
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record