Show simple item record

contributor authorYang, Huaidong
contributor authorGreen, Itzhak
date accessioned2019-03-17T10:43:56Z
date available2019-03-17T10:43:56Z
date copyright11/1/2018 12:00:00 AM
date issued2019
identifier issn0742-4787
identifier othertrib_141_03_031401.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4256285
description abstractThis work employs a three-dimensional (3D) finite element analysis (FEA) to investigate the fretting metallic contact between a deformable hemisphere and a deformable flat block. Fretting is governed by displacement-controlled action where the materials of the two contacting bodies are set to have identical properties; studied first is steel-on-steel and then copper-on-copper. At contact onset, a normal interference (indentation) is applied, which is then followed by transverse cyclic oscillations. A large range of coefficients of friction (COFs) is imposed at the interface. The results show that the maximum von Mises stress is confined under the contacting surface for small COFs; however, that maximum reaches the contacting surface when the COFs are sufficiently large. It is also shown that fretting under sufficiently large COFs forms large plastic strains in “ring” like patterns at the contacting surfaces. Junction growth is found where the contacting region is being stretched in the direction of the fretting motion. At large COFs, pileups show up at the edges of the contact. The fretting loops of the initial cycles are found along with the total work invested into the system. At certain interference, there exists a certain COF, which results in the largest work consumption. The magnitude of the COF is found to produce either partial slip (prone for fretting fatigue) or gross slip (prone for fretting wear). A scheme of normalization is proposed, and it is shown to be effective for the two said materials that have vastly different material properties. Hence, the normalized results may well characterize a range of contact scales (from micro to macro) of various ductile material pairs that behave in an elastic–plastic manner with strain hardening.
publisherThe American Society of Mechanical Engineers (ASME)
titleAnalysis of Displacement-Controlled Fretting Between a Hemisphere and a Flat Block in Elasto-Plastic Contacts
typeJournal Paper
journal volume141
journal issue3
journal titleJournal of Tribology
identifier doi10.1115/1.4041535
journal fristpage31401
journal lastpage031401-11
treeJournal of Tribology:;2019:;volume( 141 ):;issue: 003
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record