Show simple item record

contributor authorAbed, Fayadh M.
date accessioned2019-02-28T11:07:05Z
date available2019-02-28T11:07:05Z
date copyright3/13/2018 12:00:00 AM
date issued2018
identifier issn0199-6231
identifier othersol_140_04_041003.pdf
identifier urihttp://yetl.yabesh.ir/yetl1/handle/yetl/4252867
description abstractThis research is intended to design and manufacture a multilayer solar distiller at a promising cost. The solar distiller manufactured has the same design as simple water distillers, which are based on the principle of evaporation and condensation with a different energy cycle, where the processes of evaporation and condensation are completely isolated. The obtained results showed that the amount of produced water has increased by 60% compared to the traditional solar distillers, where the system is not isolated. No catalysts were used, and the areas of the evaporation and condensation have also been increased leading to the production of distilled water under natural conditions and low cost. A comparison between the theoretical and experimental results is performed. The productivity was as follows: 8.45, 11.04, 12.20, 21.44, 18.69, 16.15, and 14.49 L/day in January, February, March, September, October, November, and December, respectively.
publisherThe American Society of Mechanical Engineers (ASME)
titleDesign and Fabrication of a Multistage Solar Still With Three Focal Concentric Collectors
typeJournal Paper
journal volume140
journal issue4
journal titleJournal of Solar Energy Engineering
identifier doi10.1115/1.4039351
journal fristpage41003
journal lastpage041003-9
treeJournal of Solar Energy Engineering:;2018:;volume( 140 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record