| description abstract | Fiber-reinforced soft composites (FrSCs) are seeing increasing use in applications involving soft actuators, four-dimensional printing, biomimetic composites, and embedded sensing. The three-dimensional (3D) printing of FrSCs is a layer-by-layer material deposition process that alternates between inkjet deposition of an ultraviolet (UV) curable polymer layer and the stamping of electrospun fibers onto the layer, to build the final part. While this process has been proven for complex 3D geometries, it suffers from poor fiber transfer efficiencies (FTEs) that affect the eventual fiber content in the printed part. In order to address this issue, it is critical to first understand the mechanics of the fiber transfer process. To this end, the objective of this paper is to develop a cohesive zone-based finite element model that captures the competition between the “fiber–carrier substrate” adhesion and the “fiber–polymer matrix” adhesion, encountered during the stamping process used for 3D printing FrSCs. The cohesive zone model (CZM) parameters are first calibrated using independent microscale fiber peeling experiments involving both the thin-film aluminum carrier substrate and the UV curable polymer matrix. The predictions of the calibrated model are then validated using fiber transfer experiments. The model parametric studies suggest the use of a roller-based stamping unit design to improve the FTE of the FrSC 3D printing process. Preliminary experiments confirm that for a 0.5 in diameter roller, this new design can increase the FTE to ∼97%, which is a substantial increase from the 55% efficiency value seen for the original flat-plate stamping platen design. The model has broader applications for the transfer-printing of soft material constructs at the submicron scale. | |
