| contributor author | Gajdoš Ľubomír;Šperl Martin;Pavelková Romana | |
| date accessioned | 2019-02-26T07:53:40Z | |
| date available | 2019-02-26T07:53:40Z | |
| date issued | 2018 | |
| identifier other | %28ASCE%29AS.1943-5525.0000846.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl1/handle/yetl/4250116 | |
| description abstract | This work was motivated by the need for knowledge about the natural decrease in water pressure from room temperature creep, separate from the decrease in pressure caused by leakage in tightness tests of new and/or repaired pipelines. In this context, a case study was conducted regarding the decrease in water pressure in a test pipe with dimensions of 53 mm in outside diameter and 7.8 mm in wall thickness. The system was pressurized to a pressure of 8.985 MPa, after which the water supply was stopped. The test pipe, 4 m in length, was made from linepipe steel L36NB and was closed by torispherical heads at both ends. Special attention was given to the thermal insulation of the test pipe, ensuring an average temperature of 14.5°C, with variation within .1°C over a period of 24 h. A nonlinear ordinary differential equation was derived to describe the time gradient of the water pressure in the test pipe in relation to time, pressure, coefficient of compressibility of water, and cross-sectional dimensions of the test pipe. The necessary creep parameters and static tensile properties were obtained from specimens manufactured from a ring 3 cm in width taken from the same pipe. The orientation of the specimens was circumferential. The creep tests were performed over a period of 24 h at ambient temperature. The creep strains were measured by the strain gauge technique, and the effect of temperature variation during the test period (24 h) was compensated by the use of a compensating strain gauge. The calculated decrease in pressure with time compared quite well with experimental results when the beginning of the pressure decrease was considered 2 h after reaching the initial pressure of water (p=8.985 MPa) and the supply of water was ended. The time period of 2–24 h follows the recommendations of a pipeline operating pressure standard. A family of “pressure-time” curves were constructed for a pipe from steel pressurized by water to specific initial pressure levels taken as multiples of the pressure at the yield. These curves cover a time interval of 2–24 h, and they can be used to check the total decrease in water pressure after the tightness test has been completed. | |
| publisher | American Society of Civil Engineers | |
| title | Pressure Behavior of a Steel Pipeline Experiencing Creep at Normal Temperatures | |
| type | Journal Paper | |
| journal volume | 31 | |
| journal issue | 3 | |
| journal title | Journal of Aerospace Engineering | |
| identifier doi | 10.1061/(ASCE)AS.1943-5525.0000846 | |
| page | 5018001 | |
| tree | Journal of Aerospace Engineering:;2018:;Volume ( 031 ):;issue: 003 | |
| contenttype | Fulltext | |