Journal of Vibration and Acoustics: Recent submissions
Now showing items 3641-3660 of 3913
-
The Modal Density of Honeycomb Shells
(The American Society of Mechanical Engineers (ASME), 1986) -
Wave Propagation and Attenuation in Piping Systems
(The American Society of Mechanical Engineers (ASME), 1986)Results of an investigation on wave propagation in two-dimensional fluid-filled piping systems is reported. This phenomenon is studied by first developing a model for the transmission of solid-borne ... -
The Adaptation of Kron’s Method for Use With Large Finite-Element Models
(The American Society of Mechanical Engineers (ASME), 1986)Kron’s method of dynamic substructure coupling is modified and extended to a form which is well suited for use with large finite-element substructure models. It is shown how both mass condensation ... -
Autoparametric Vibration of Coupled Beams Under Random Support Motion
(The American Society of Mechanical Engineers (ASME), 1986)The dynamic response of a two degree-of-freedom system with autoparametric coupling to a wide band random excitation is investigated. The analytical modeling includes quadratic nonlinearity, and ... -
Modeling General Hysteresis Behavior and Random Vibration Application
(The American Society of Mechanical Engineers (ASME), 1986)A simple constructive technique for the development of rate-type hysteresis models for general nonlinear system is presented. The technique is used to develop hysteresis models to incorporate ... -
Structural Optimization of Cantilever Mechanical Elements
(The American Society of Mechanical Engineers (ASME), 1986)Naturally limited stiffness of cantilever elements due to lack of constraint from other structural components, together with low structural damping, causes intensive and slow-decaying transient ... -
Introduction to Random Vibration
(The American Society of Mechanical Engineers (ASME), 1986) -
Instrumentation for Engineering Measurements
(The American Society of Mechanical Engineers (ASME), 1986) -
Fundamentals of Mechanical Vibration
(The American Society of Mechanical Engineers (ASME), 1986) -
Mechanics of Materials (2nd Ed.)
(The American Society of Mechanical Engineers (ASME), 1986) -
Safety and Reliability of Existing Structures
(The American Society of Mechanical Engineers (ASME), 1986) -
Discussion: “An Improved Transfer Matrix-Direct Integration Method for Rotor Dynamics” (Gu, Jialiu, 1986, ASME J. Vibr. Acoust. Stress Rel. Des., 108, pp. 182–188)
(The American Society of Mechanical Engineers (ASME), 1986) -
Critical Spin Rate of Rotating Beams by Liapunov’s Direct Method
(The American Society of Mechanical Engineers (ASME), 1986)The in-plane and out-of-plane buckling of a beam subjected to axial loads due to steady rotation are investigated for various boundary conditions. The critical spin rate which will cause the ... -
Rapid Measurement of Modal Properties Using FFT Analyzers With Random Excitation
(The American Society of Mechanical Engineers (ASME), 1986)The use of a Nyquist plot of the H2 (Syy /Sxy *) frequency response function estimates produced by an FFT based spectrum analyzer with random excitation to obtain modal amplitudes and hence ... -
Proceedings Inter-Noise 84 (2 Vols.)
(The American Society of Mechanical Engineers (ASME), 1986) -
A Simple Numerical Method for Determining the Sensitivity of Bending Deflections of Stepped Shafts to Dimensional Changes
(The American Society of Mechanical Engineers (ASME), 1985)A simple method of computing the effect of a dimensional change at a particular element of a stepped shaft on two bearings, on bending deflections, and on slopes of the neutral axis at any ... -
Computer-Aided Design of Power Transmission Shafts Subject to Size, Strength, and Deflection Constraints Using a Nonlinear Programming Technique
(The American Society of Mechanical Engineers (ASME), 1985)The problem of synthesis of power transmission shafts supported on two bearings, subject to dimensional, strength, and deflection constraints is posed as a nonlinear programming (NP) problem. The ... -
Probabilistic Methods in Structural Engineering
(The American Society of Mechanical Engineers (ASME), 1985) -
Editorial
(The American Society of Mechanical Engineers (ASME), 1985) -
Limitation of Simplified Hypotheses for the Prediction of Torsional Oscillations for Thin-Walled Beams
(The American Society of Mechanical Engineers (ASME), 1985)The study of uniform torsion of thin walled beams is done fairly easily in the thin wall beam case, the effects of thickness being neglected. Then, the classical Saint-Venant warping function ...