Journal of Vibration and Acoustics: Recent submissions
Now showing items 3301-3320 of 3913
-
Structural Analysis on Computers
(The American Society of Mechanical Engineers (ASME), 1989) -
Analysis of a High-Speed Flexible Four-Bar Linkage: Part I—Formulation and Solution
(The American Society of Mechanical Engineers (ASME), 1989)Derived from the principle of virtual displacement, a general finite element analysis computer code (FEMAP) of the flexible four-bar linkage is developed on the Apollo computer. In this part, ... -
Experiments on Dynamic Stiffness and Damping of Tapered Bore Seals
(The American Society of Mechanical Engineers (ASME), 1989)Stiffness and damping were measured in tapered bore ring seals with air as the sealed fluid. Excitation was provided by a known unbalance in the shaft which rotated in the test seals. Results ... -
Seismic Induced Nonlinear Rotor-Bearing-Casing Interaction of Rotating Nuclear Components
(The American Society of Mechanical Engineers (ASME), 1989)The study of the dynamics of turbomachinery during seismic events has been of continuous interest to both researchers and designers of large rotating equipment. Failure in such equipment, ... -
Instability Due to Fluid Leakage of a Rotor System With Anisotropic Support
(The American Society of Mechanical Engineers (ASME), 1989)The instability caused by the fluid leakage leads to a limited performance of turbomachines. This instability may be improved by using flexible bearing supports with anisotropic stiffness. With ... -
Probability, Random Variables and Stochastic Processes (2nd Edition)
(The American Society of Mechanical Engineers (ASME), 1989) -
Proceedings of Sixth International Modal Analysis Conference (IMAC)
(The American Society of Mechanical Engineers (ASME), 1989) -
Automatic Generation of Component Modes for Rotordynamic Substructures
(The American Society of Mechanical Engineers (ASME), 1989)Dynamic analysis models are customarily employed in turbomachinery design to predict critical whirling speeds and estimate dynamic response due to loads imposed by unbalance, misalignment, maneuvers, ... -
Notes on Vibration Frequency Analysis
(The American Society of Mechanical Engineers (ASME), 1989) -
Finite Elements—Special Problems in Solid Mechanics (Vol. V)
(The American Society of Mechanical Engineers (ASME), 1989) -
Fundamentals of Noise Control Engineering
(The American Society of Mechanical Engineers (ASME), 1989) -
Shaft Alignment Handbook
(The American Society of Mechanical Engineers (ASME), 1989) -
Signal Recovery From Noise in Electronic Instrumentation
(The American Society of Mechanical Engineers (ASME), 1989) -
Random Vibration of Structures
(The American Society of Mechanical Engineers (ASME), 1989) -
Periodic Solutions in Rotor Dynamic Systems With Nonlinear Supports: A General Approach
(The American Society of Mechanical Engineers (ASME), 1989)A new quantitative method of estimating steady state periodic behavior in nonlinear systems, based on the trigonometric collocation method, is outlined. A procedure is developed to analyze large ... -
Improved Rotor Response of the Uprated High Pressure Oxygen Turbopump for the Space Shuttle Main Engine
(The American Society of Mechanical Engineers (ASME), 1989)During development testing of the High Pressure Oxygen Turbopump (HPOTP) of the Space Shuttle Main Engine (SSME) to produce 109 percent of the rated thrust level, subsynchronous rotor whirl was ... -
Far Field Acoustic Radiation From an Expansion Chamber
(The American Society of Mechanical Engineers (ASME), 1989)A method is presented for the assessment of the effect of several system parameters on the radiated and transmitted acoustic fields of an expansion chamber with a flexible side wall. The ... -
Unbalance Response of Flexible Rotors Coupled With Torsion
(The American Society of Mechanical Engineers (ASME), 1989)The effect of coupling with torsion on the unbalance response of flexible rotors, supported by isotropic flexible and damped bearings is investigated. Flexural vibrations of the shaft-disk system ... -
Uniaxial and Equibiaxial Strength of a Vitreous-Bonded Abrasive
(The American Society of Mechanical Engineers (ASME), 1989)The inert strength of a vitreous-bonded abrasive material was measured using bars in four-point bending and disks in ring-on-ring flexure. It was found that the strength of the bend bars could ... -
The Residual Shaft Bow Effect on Dynamic Response of a Simply Supported Rotor With Disk Skew and Mass Unbalances
(The American Society of Mechanical Engineers (ASME), 1989)The effect of residual shaft bow on the dynamic response of a simply supported single disk rotor with disk skew and mass unbalances is studied. The influence of disk-positioning between bearings ...