Journal of Bridge Engineering: Recent submissions
Now showing items 281-300 of 3153
-
Comparative Study on the Wake-Induced Vibration of PWS and WR Six-Cable Hangers of Suspension Bridges and Its Mitigation
(ASCE, 2024/02/01)With the continuous increase in the span of suspension bridges, six-cable hangers have been gradually adopted to meet the load requirements in the design of suspension bridges. However, the aerodynamic interference between ... -
Assessing Granular Debris-Flow Impact Forces on Bridge Superstructures
(ASCE, 2024/06/01)In countries similar to Austria, bridges fail due to debris-flow impact on a regular basis. As there is a large uncertainty in terms of the acting forces during these events, this study examines debris-flow impact forces ... -
Machine Learning–Based Bridge Maintenance Optimization Model for Maximizing Performance within Available Annual Budgets
(ASCE, 2024/04/01)Effective maintenance planning for bridges is crucial for maintaining their performance, safety, and minimizing maintenance costs. Timely implementation of interventions can improve the performance of bridges and avoid the ... -
Rocking Bridge Columns with External Replaceable Tendons
(ASCE, 2024/03/01)Columns are usually the weak links in conventional bridges with regard to seismic design. Damage of reinforced concrete (RC) columns caused by moderate earthquakes is usually repairable, but significant damage is expected ... -
Fatigue Performance of a Novel Steel–Concrete Joint of a Long-Span High-Speed Railway Hybrid Girder–Cable-Stayed Bridge
(ASCE, 2024/01/01)The steel–concrete joint (SCJ) of a railway hybrid girder–cable-stayed bridge transmits tremendous internal forces, resulting in complex structure and stress. The existing complex SCJs lead to difficulties in on-site ... -
Experimental and Numerical Study of Grout Effectiveness and Force-Transfer Mechanism in Socket Connections
(ASCE, 2024/04/01)This study aims to investigate the effectiveness of grout and the mechanism of force transfer in socket connections. In doing so, it proposes a new transfer mode called integral transfer mode (ITM), as opposed to the ... -
Convoluted Reciprocity and Other Methods for Vehicle Speed Estimation in Bridge Weigh-in-Motion Systems
(ASCE, 2024/02/01)In bridge weigh-in-motion systems, the vehicle speed is a fundamental input parameter for the weighing algorithm. The speed is generally obtained by processing structural responses measured at different locations along the ... -
Deformation of a Tapered Box Girder with Trapezoidal Corrugated Steel Webs Considering the Resal Effect: Theory, Experiments, and Numerical Simulations
(ASCE, 2024/02/01)Due to the weakened shear stiffness of trapezoidal corrugated steel webs (TCSWs), it is necessary to account for shear deformation in calculating the total deformation for girders with TCSWs. Most of the existing research ... -
Quantitative Assessment Framework for the Postearthquake Traffic Flow Capacity of Bridges Based on the Loss Model of Vertical Load-Carrying Capacity
(ASCE, 2024/03/01)This paper aimed to propose an analytical framework for assessing the postearthquake traffic flow capacity of girder bridges based on the loss model of vertical load-carrying capacity. For this purpose, a loss model of the ... -
Vibration Damping of a Taut Cable with the Hybrid Application of a Viscous Damper and a Tuned Mass Damper
(ASCE, 2024/05/01)Additional damping provided by a viscous damper (VD) may not be sufficient to mitigate the wind-induced vibration of long cables. In this paper, the damping properties of the hybrid application of a VD and a tuned mass ... -
Corrosion-Fretting Fatigue Analysis of Bridge Cables Based on Multifactor Competition Model and Time-Dependent Reliability
(ASCE, 2024/01/01)Bridge cables are the safety lifelines of cable-supported bridges. However, many suspenders in cable-supported bridges were inaccurately evaluated and suffered from premature damage under complex environmental and load ... -
Investigation of the Shear Lag Effect of an Innovative Steel Box Girder in Cable-Stayed Bridges: Experimental and Bar Simulation Method Analysis
(ASCE, 2024/03/01)As an innovative steel box girder, the normal stress patterns in the top and bottom plates of a cantilever steel box girder are complex. However, the influence of external and internal struts on the shear lag effect is ... -
A Rapid Evaluation Method for the Vertical Condition of Bridge Substructures Using Bayesian System Identification and Output-Only Measurements
(ASCE, 2024/02/01)Evaluating the bearing capacity of bridge substructures is very important for bridge maintenance and management. However, existing studies that rely on static load tests (SLTs) or transient response methods (TRMs) have ... -
Aerodynamic Interference Effects on Vortex-Induced Vibration of Two Parallel Railway– and Highway–Cable-Stayed Bridges with Triple-Separated Decks
(ASCE, 2024/02/01)In this study, wind tunnel tests were carried out to study the vortex-induced vibration (VIV) characteristics of two parallel long-span railway– and highway–cable-stayed bridges with triple-separated parallel decks. ... -
Assessment of the Seismic Demands Posed to Suspension Bridges in the Near Field with Site-Specific Arrays of Simulated Ground Motions
(ASCE, 2024/05/01)A key component of infrastructure seismic risk assessment is the execution of nonlinear time-history analyses with a suite of selected ground motions scaled to site-specific spectra. When interested in the evaluation of ... -
A Strut-and-Tie Model Approach to Design Precast Column-to-Pile Shaft Member Socket Connections against Prying-Action Failure
(ASCE, 2024/05/01)This study presents a seismic design methodology for precast concrete column-to-pile shaft member socket connections. In designing such connections, the intent was to ensure that the plastic hinge occurs in columns while ... -
A Benchmark Data Set for Vision-Based Traffic Load Monitoring in a Cable-Stayed Bridge
(ASCE, 2024/02/01)Traffic load monitoring based on deep learning and computer vision has garnered significant attention in bridge engineering worldwide. Unlike traditional traffic load monitoring systems, computer vision-based techniques ... -
Vertical Clearance Assessment for Highway Bridges Based on Multisensor Fusion Simultaneous Localization and Mapping
(ASCE, 2024/02/01)The three-dimensional (3D) reconstruction method based on computer vision technology greatly facilitates the automated performance inspection and assessment of transportation infrastructure, in which the acquisition of ... -
Live Load Distribution Factors for Steel Press-Brake-Formed Tub Girder Bridges
(ASCE, 2024/02/01)Accelerated bridge construction (ABC) has been widely used in the United States since the late 1990s following a national ABC initiative by the Transportation Research Board (TRB) in 1996. The press-brake-formed tub girder ... -
Dynamics and Seismic Performance of Bridges with Rocking Piers of Nonconventional Configuration
(ASCE, 2024/06/01)The present study focuses on the seismic response of bridges with rocking piers of nonconventional shape, combining the inherent benefits of rocking isolation and accelerated bridge construction. The governing equations ...