Journal of Materials in Civil Engineering: Recent submissions
Now showing items 2081-2100 of 7936
-
Evaluation of One-Part Slag–Fly-Ash Alkali-Activated Mortars Incorporating Waste Glass Powder
(ASCE, 2022/12/01)This paper describes an experimental investigation into the properties of ambient cured one-part alkali-activated materials (AAMs). Mixes incorporating waste glass (WG), ground granulated blast-furnace slag (GGBS), fly ash ... -
Preparation of Magnesium Oxysulfate Cement with Calcined Phosphate Tailings
(ASCE, 2022/12/01)Recycling of phosphate tailings (PT) in cement production can reduce the amount of this solid waste and its consequent pollution. This paper used high content of calcined PT as an alternative to light-burned magnesia to ... -
The Effect of Tire-Rubber Pretreatment on the Physical–Mechanical Properties and Durability of High-Performance Concrete
(ASCE, 2022/12/01)High-performance concrete (HPC) is known as a material of high strength and high durability. This investigation is focused on the influence of the use of rubber waste tires on the physical, mechanical, and durability ... -
Study on Ions Leachability and Microstructure of FGD Gypsum–Based Material Mixed with Cement and Slag by Isothermal Calorimetry and Low-Field Nuclear Magnetic Resonance
(ASCE, 2022/12/01)Flue gas desulphurization (FGD) gypsum is a kind of industrial solid waste containing impurities (i.e., heavy metal ions Zn2+ and Ni2+), which may lead to threats to the ecological environment and public health. To ... -
Study of Properties and Mechanism of Bonding Line in Three-Layer Hybrid Cross-Laminated Timber
(ASCE, 2022/12/01)The physical and chemical properties of three kinds of laminations relative to the bonding properties of three-layer hybrid cross-laminated timber (CLT) were studied. The density of the parallel layer lamination of CLT was ... -
Fiber Efficiency on the Flow Behaviors and Compressibility-Permeability of Fiber-Reinforced Cemented Waste Slurry
(ASCE, 2022/12/01)A series of laboratory tests including flow consistency, viscosity, one-dimensional compression, and permeability were conducted on the fiber-reinforced cemented waste slurries obtained from a construction site to evaluate ... -
Experimental Investigation of the Bond Performance between Nonuniformly Corroded Reinforcing Bar and Concrete
(ASCE, 2022/12/01)In this study, bond failure tests were carried out on eight beam anchorage specimens after accelerated corrosion, and the crack widths on the concrete surface and the nonuniform corrosion characteristics of the reinforcing ... -
Evaluation of Mechanical Properties of Concrete Containing Recycled Concrete Aggregate and Recycled Asphalt Pavement
(ASCE, 2022/12/01)In this study, the mechanical properties and microscopic structure of concretes containing natural coarse aggregates (NCAs), recycled concrete aggregates (RCAs), and recycled asphalt pavement (RAP) aggregates are investigated. ... -
Rheological Properties and Mechanism of Asphalt Modified with Polypropylene and Graphene and Carbon Black Composites
(ASCE, 2022/12/01)The application of polypropylene (PP) to asphalt pavement construction, as one of the measures to dispose white waste, has suffered from many challenges. Meanwhile, the emerging nanomaterials for asphalt pavements has ... -
Preparation and Mix Design of Usual-Temperature Synthetic Pitch–Modified Cutback Asphalt
(ASCE, 2022/12/01)Usual-temperature synthetic pitch (USP) is a modifier that can efficiently reduce the mixing temperature and improve the overall engineering properties of warm-mix asphalts; however, few studies are reported for its ... -
Performance of Multiwalled Carbon Nanotube Doped Fired Clay Bricks
(ASCE, 2022/12/01)In this study, the effect of multiwall carbon nanotubes (MWCNTs) on various properties of a fired clay brick was investigated and subsequently compared with other kinds of bricks. MWCNT doped bricks and traditional bricks ... -
Influence of Copper Slag on Mechanical Performance, Hydrate Assemblage, and Mechanism of Cementitious System
(ASCE, 2022/12/01)Copper slag (CS) is a by-product generated during the process of copper metal smelting. The influence of CS on the mechanical performance, hydrate assemblage, and mechanism of the cementitious system was investigated by ... -
Formulation of a New Rejuvenator and Its Regenerative Effect on Aged Asphalt
(ASCE, 2022/12/01)A massive amount of recycled asphalt pavement (RAP) is produced in road construction and maintenance, and using rejuvenators to rejuvenate RAP can have a significant economic benefit. At present, a biorejuvenator is used ... -
Investigation of the Performance of Bituminous Binder Modified with Calcium Carbonate and Polyethylene Compound
(ASCE, 2022/12/01)In this study, the usability of calcium carbonate-polyethylene compound (PEC) was investigated as an alternative to styrene-butadiene-styrene (SBS), which is one of the most used additives in bitumen modification. The ... -
Surface-Roughness-Induced Control of the Interfacial Failure Mode and Bonding Strength: Atomistic Case Study in an Asphalt–Aggregate System
(ASCE, 2022/12/01)The surface roughness prior to adhesive bonding plays an important role in enhancing the durability of composite materials. To obtain deep insight into the effect of aggregate surface roughness on the interfacial properties ... -
Multi-Index Evaluation for Anticracking Performance of Epoxy Porous Asphalt Mixtures Based on Overlay Test
(ASCE, 2022/12/01)Porous asphalt pavement have been widely employed for various functions. However, due to its large voids and small contact area between particles, the reflective cracks results from semirigid base layer shrinkage cracking ... -
A Study on Chemical Composition, Colloidal Stability, and Rheological Properties of Ethylene Vinyl Acetate–Modified Binders
(ASCE, 2022/12/01)The rheological properties and performance of binders are often explained using the chemical composition of binders. The present study explored the effect of SARA fractions (saturates, aromatics, resins, and asphaltenes) ... -
Influence of Chloride Transport Modes and Hydrated Cement Chemistry on Chloride Profile and Binding Mechanisms in Concrete
(ASCE, 2022/12/01)A chloride binding model consisting of physical adsorption and chemical ion exchange was proposed. Chemical binding was quantified based on the thermodynamic equilibrium of the relevant hydrated phases while physical ... -
Effect of Stress Path on the Damage Properties of Concrete under High Pressure
(ASCE, 2022/12/01)The primary objective of this study was to investigate the constitutive relations and damage properties of concrete in complex stress states with different stress paths under high pressure. Monotonic hydrostatic pressure, ... -
Percolation Approach to Determine Filter Criteria in Geotextile Filter Design
(ASCE, 2022/12/01)Geotextile filters are used widely in overflow hydraulic structures to prevent long-term particle loss and internal erosion in cohesionless soils. Filter criteria have been proposed and developed for the geotextile filter ...