Journal of Materials in Civil Engineering: Recent submissions
Now showing items 1521-1540 of 7936
-
Curing Law and Strength-Age Prediction Model of a Dense Polyurethane Mixture under the Influence of Moisture and Temperature
(ASCE, 2024/03/01)The strength development of pavement polyurethane mixture is primarily dependent on the degree of curing reaction of polyurethane adhesive. In this work, the effects of temperature, humidity, and curing time on the curing ... -
Investigation on Physical and Chemical Protecting Mechanism of SME-PS as a Concrete Surface Protectant
(ASCE, 2024/01/01)Soy methyl ester-polystyrene (SME-PS) is a biodegradable and nontoxic blend of soybean oil and waste polystyrene that can be used as a surface treatment to improve concrete deterioration and rebar corrosion caused by ... -
Investigation of the Pore Structures and Water Absorbency of Foamed Alkali-Activated Binders
(ASCE, 2024/03/01)Water absorbency of foamed alkali-activated binders (FAABs) with various pore distributions were investigated in this study, where the pore structures were characterized and analyzed quantitatively to expound the mechanism ... -
Bridging Field and Laboratory Permeabilities of Pervious Pavement Mixtures Using XRCT-Based Numerical Modeling
(ASCE, 2024/04/01)Drainage capacity of pervious pavement mixtures is commonly measured using a falling head permeameter at hydraulic heads much higher than expected in the field. Recent advancements in computational fluid dynamics (CFD)– ... -
Crack Bioremediation in Concrete by Photoautotrophic Cyanobacteria through Fly Ash–Based Cementitious Biogrout
(ASCE, 2024/02/01)Microbially induced calcium carbonate precipitation (MICCP) is widely employed in various engineering applications, including repairing cracks in cementitious materials. Many of these studies were performed using heterotrophic ... -
Volume Change Behavior of Amended Expansive Soil Using Sugarcane Bagasse Ash-Based Geopolymer
(ASCE, 2024/04/01)This study aimed to address pavement cracking caused by the high swell-shrink behavior of expansive soils, resulting from fluctuations in moisture content and high clay content, by using an eco-friendly nontraditional ... -
Fire-Induced Damage and Postfire Analysis of the Compression Properties of Cross-Laminated Timber
(ASCE, 2024/03/01)When exposed to fire, load-bearing mass timber structures, such as cross-laminated timber (CLT), soften and decompose, which causes significant deformation and weakening, ultimately leading to failure. A combined experimental ... -
Prediction of Skid Resistance of Steel Slag Asphalt Mixture Based on Grey Residual GM(1,1)-Markov Model
(ASCE, 2024/01/01)To predict the long-term skid resistance of steel slag asphalt mixtures, accelerated wear tests were conducted using an indoor accelerated loading device on the steel slag asphalt mixtures with different aggregate types, ... -
Dynamic Electrochemical Model of Steel Corrosion in Concrete Microenvironment under Multifield Action of Heat-Moisture-Chlorine
(ASCE, 2024/01/01)This study utilized a heat-moisture coupling model to characterize the internal microenvironment of concrete and establish the relationship between environmental temperature, humidity, external chloride ions, corrosion ... -
Green Fabrication of Superhydrophobic Zeolite Coating on Cement-Based Material Surfaces to Improve Water-Resistant and Anticorrosion Properties
(ASCE, 2024/05/01)Constructing a superhydrophobic coating on cement-based materials’ surface can effectively inhibit the invasion of external water and corrosive ions. However, current strategies of fabricating superhydrophobic coatings ... -
Improved Performance of Natural Rubber Latex–Modified Asphalt Concretes with Various Types of Aggregates
(ASCE, 2024/01/01)The influence of aggregate properties and natural rubber latex (NRL) additive on the performance of natural rubber modified asphalt (NRMA) concrete mixtures was investigated. The NRMA mixtures were prepared using three ... -
Response Variability of Diffusion Models Applied to Chloride Concentration Profiles from Concrete Structures
(ASCE, 2024/01/01)Chloride profiles can be used to assess the durability of concrete structures against corrosion in the marine environment. However, the models proposed to adjust these chloride profiles are diverse and have varied complexities. ... -
Carbonation-Induced Corrosion on Concrete with Waste Brick Powder and Hydrated Lime Additive
(ASCE, 2024/01/01)This study explores the possibility of partially replacing cement with crushed brick powder (CBP) and 6% hydrated lime (HL) in concrete. The results showed an increase in compressive strength compared with the control at ... -
Experimental Study on the Performance of Lap-Spliced Steel Bars in Ultrahigh-Performance Concrete
(ASCE, 2024/01/01)Ultrahigh-performance concrete (UHPC) is a new cementitious composite material that exhibits a high bond strength with steel reinforcement. To investigate the splice performance levels of steel bars in UHPC, mutual pullout ... -
Recycled Concrete Aggregate Stabilized with Lime-Fly Ash and Cement for Utilization as a Semirigid Base Course of Low-Volume Roads
(ASCE, 2024/04/01)This study examined the mechanical characteristics of recycled concrete aggregate (RCA) stabilized with lime–fly ash (LFA) and cement for utilization as a semirigid base course of low-volume roads (LVRs). Several laboratory ... -
Investigation of Using Ulexite as a Filler in Various Combinations in Stone Mastic Asphalt Mixtures
(ASCE, 2024/02/01)Ulexite is one of the most commonly used minerals in boron elements. Especially with the increase in infrastructure investments, new raw materials and new asphalt mixtures with higher performances than traditional asphalt ... -
Analysis of Flexural Fatigue for Pavement Quality Concrete Containing Copper Slag as Replacement of River Sand
(ASCE, 2024/01/01)An investigation was carried out to analyze the flexural fatigue performance of pavement quality concrete (PQC) of M40 and M50 grades, made with conventional materials out of which river sand (RS) was replaced by copper ... -
Development of Preplaced Alkali-Activated Coral Concrete for a Marine Environment
(ASCE, 2024/01/01)The use of coral aggregate (CA) in marine concrete can greatly reduce project costs and periods. An environmentally friendly alkali-activated material (AAM) was used to grout CA to produce preplaced alkali-activated coral ... -
The Physicomechanical Behavior and Microstructure of Air-Entrained 3D Printable Concrete
(ASCE, 2024/01/01)The effects of air-entraining admixture (AEA), curing process, and core direction were studied as parameters in terms of their effect on the physicomechanical properties of 3D printed concrete. Four different AEA dosages ... -
Optimum Fines Content in Manufactured Sand for Best Overall Performance of Superplasticized Concrete
(ASCE, 2024/01/01)Due to a shortage of river sand for concrete production, manufactured sand (MS) made from crushed rock has gradually become a substitute. It inherently contains some fines content, which has significant effects on the ...