Detection of Cavitation in a Venturi Injector With a Combined Method of Strain Gauges and Numerical Simulation

Abstract

The fertilizer suction capability of a Venturi injector is dependent on the vacuum pressure in the throat portion. As the vacuum level drops below the saturation vapor pressure, the pressure decreases to a particular value corresponding to the maximum pressure difference (خ”pmax) between inlet and outlet pressures, and critical cavitation is likely to occur, leading to an unstable suction flow rate and low fertilization uniformity. A new method of using strain gauges to detect cavitation in Venturi injectors was explored experimentally and verified numerically under various operating conditions. The standard deviation (SD) of the measured strain values and the simulated values of the vaporphase volume fraction (Vf) were used to evaluate the influence of cavitation. The results showed that both the rate of increase (خ·m) of the average SD and the average growth rate (AGR) of the simulated cavitation length reach relatively large values at the maximum pressure difference (خ”pmax), where the measured suction flow rate simultaneously reaches a maximum. In addition, SD and Vf shared similar variation trends at pressure differences larger than the corresponding خ”pmax under various conditions. This new cavitation detection method has been proved to be feasible and reliable. It helps to determine accurately the value of خ”pmax at different inlet pressures and to ensure that the Venturi injector runs in a safe operatingpressure range.