| contributor author | Shanmugan, S. | |
| contributor author | Mutharasu, D. | |
| date accessioned | 2017-05-09T01:06:52Z | |
| date available | 2017-05-09T01:06:52Z | |
| date issued | 2014 | |
| identifier issn | 1528-9044 | |
| identifier other | ep_136_03_034502.pdf | |
| identifier uri | http://yetl.yabesh.ir/yetl/handle/yetl/154490 | |
| description abstract | AlN thin film was coated over Cu substrate (575 mm2) with 400 nm thickness using DC sputtering for thermal interface material (TIM) application. Aluminum Nitride (AlN)coated Cu substrate (AlN/Cu) was used as a heat sink for 3W green light emitting diode (LED). The thermal transient curve was recorded for given LED attached with bare Cu and AlNcoated Cu substrate at three different driving currents. LED attached on AlN/Cu showed the reduced raise in junction temperature (TJ) by 2.59 آ°C at 700 mA. The LED/TIM/AlN/Cu boundary condition was not supported to reduce the TJ. The total thermal resistance (Rthtot) was reduced for AlNcoated Cu substrate at 350 mA. The thermal resistance between metal core printed circuit board and Cu substrate (Rthbhs) was also observed as low for AlNcoated Cu substrates compared with other boundary conditions measured at 700 mA. The observed results were supported for the use of AlN thin film as TIM in high power LEDs. | |
| publisher | The American Society of Mechanical Engineers (ASME) | |
| title | Thermal Resistance Analysis of High Power Light Emitting Diode Using Aluminum Nitride Thin Film Coated Copper Substrates as Heat Sink | |
| type | Journal Paper | |
| journal volume | 136 | |
| journal issue | 3 | |
| journal title | Journal of Electronic Packaging | |
| identifier doi | 10.1115/1.4027379 | |
| journal fristpage | 34502 | |
| journal lastpage | 34502 | |
| identifier eissn | 1043-7398 | |
| tree | Journal of Electronic Packaging:;2014:;volume( 136 ):;issue: 003 | |
| contenttype | Fulltext | |