Assessing Position Error Due to Clearances and Deformations of Links in Parallel Manipulators

Abstract

Two of the main sources of position error in parallel manipulators are clearances at joints and elastic deformations of the links. The former are usually necessary in order to produce a smooth movement between the pin and the hub of a joint. The latter are unavoidable and they tend to be greater in manipulators designed for pickandplace tasks due to the need of light links. It can be stated that the endeffector pose error depends on the mechanism configuration, the applied external wrenches, the nature and magnitude of clearances, and the rigidity of the mechanical components. This paper proposes a procedure to calculate position error in parallel manipulators due to both clearances and elastic deformations. Although the procedure is applicable to any planar or spatial parallel manipulator, a planar 5R mechanism is used as an illustrative example in order to make it easier to understand.