Show simple item record

contributor authorR. Giorgi
contributor authorM. Alvisi
contributor authorTh. Dikonimos
contributor authorD. Valerini
contributor authorE. Serra
contributor authorM. F. De Riccardis
contributor authorN. Lisi
contributor authorL. Giorgi
contributor authorS. Gagliardi
contributor authorE. Salernitano
date accessioned2017-05-09T00:44:36Z
date available2017-05-09T00:44:36Z
date copyrightAugust, 2011
date issued2011
identifier issn2381-6872
identifier otherJFCSAU-28949#041004_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/146459
description abstractThe real market penetration of polymer electrolyte fuel cells is hindered by the high cost of this technology mainly due to the expensive platinum catalyst. Two approaches are followed to reduce the cost: one way is to increase the Pt utilization efficiency reducing at the same time the total load and the other way is to increase the catalytic activity of the catalyst/support assembly. In this work, the increase of utilization efficiency is addressed by optimizing the catalyst distribution on the uppermost layer of the electrode via electrodeposition and sputter deposition, while the improvement of the catalyst activity is pursued by nanostructuring the catalysts and the carbon-based supports. A very low Pt loading (0.006 mg cm−2) was obtained by sputter deposition on electrodes that exhibited a mass specific activity for methanol oxidation reaction better than a commercial product. Carbon nanofibers used as catalyst support of electrodeposited platinum nanoparticles resulted in improved mass specific activity and long term stability compared to conventional carbon-based supports. Finally, PtAu alloys developed by sputter deposition were found more efficient than commercial PtRu catalyst for the methanol oxidation reaction. In conclusion, polymer electrolyte membrane fuel cell electrode based on nanomaterials, developed by combining physical and chemical deposition processes, showed outstanding electrochemical performance.
publisherThe American Society of Mechanical Engineers (ASME)
titleNanomaterials-Based PEM Electrodes by Combining Chemical and Physical Depositions
typeJournal Paper
journal volume8
journal issue4
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.4003629
journal fristpage41004
identifier eissn2381-6910
keywordsNanoparticles
keywordsCarbon
keywordsElectrodes
keywordsCatalysts
keywordsPlatinum
keywordsGas diffusion layers
keywordsNanomaterials
keywordsAlloys
keywordsStress
keywordsNanofibers
keywordsoxidation
keywordsMethanol AND Proton exchange membranes
treeJournal of Fuel Cell Science and Technology:;2011:;volume( 008 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record