Show simple item record

contributor authorAlem Tesfai
contributor authorPaul Connor
contributor authorJulie Nairn
contributor authorJohn T. S. Irvine
date accessioned2017-05-09T00:44:29Z
date available2017-05-09T00:44:29Z
date copyrightDecember, 2011
date issued2011
identifier issn2381-6872
identifier otherJFCSAU-28951#061001_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/146405
description abstractRolled tubular solid oxide fuel cells are manufactured in a low-cost single step firing process, so the design offers reduced production cost. All components are produced using a low cost tape casting method and are fired as a single unit. The geometry is self–supporting which removes the need for thick cell components further reducing cell cost and offering increased volumetric power densities. Here we present the results from some early studies on the influence of fast thermal cycling on performance characteristics. Thermal cycles were carried out heating and cooling at 10 °C min−1 between 400 and 800 °C. Less than 1% performance drop was calculated for the single cell and 5% drop was observed on the fourth cycle for the five cell bundle.
publisherThe American Society of Mechanical Engineers (ASME)
titleThermal Cycling Evaluation of Rolled Tubular Solid Oxide Fuel Cells
typeJournal Paper
journal volume8
journal issue6
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.4004638
journal fristpage61001
identifier eissn2381-6910
keywordsTemperature
keywordsAnodes
keywordsDesign
keywordsSolid oxide fuel cells
keywordsCycles
keywordsDrops
keywordsGeometry
keywordsTape casting
keywordsHeating and cooling
keywordsFuel cells
keywordsElectrical resistance AND Impedance (Electricity)
treeJournal of Fuel Cell Science and Technology:;2011:;volume( 008 ):;issue: 006
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record