| description abstract | Mass transfer rates were measured in a large scale system, which is consisted of an 8.4 m tall by 0.76 m diameter column, containing one of the three fluids: water with an antifoam agent, water without an antifoam agent, and AZ101 simulant, which simulated a non-Newtonian nuclear waste. The testing contributed to the evaluation of large scale mass transfer of hydrogen in nuclear waste tanks. Due to its radioactivity, the waste was chemically simulated and due to flammability concerns, oxygen was used in lieu of hydrogen. Different liquids were used to better understand the mass transfer processes, where each of the fluids was saturated with oxygen, and the oxygen was then removed from the solution as air bubbled up or sparged through the solution from the bottom of the column. Air sparging was supplied by a single tube, which was co-axial to the column; the decrease in oxygen concentration was recorded, and oxygen measurements were then used to determine the mass transfer coefficients to describe the rate of oxygen transfer from solution. Superficial, average, sparging velocities of 2 mm/s, 5mm/s, and 10 mm/s were applied to each of the liquids at three different column fill levels, and mass transfer coefficient test results are presented here for combinations of superficial velocities and fluid levels. | |
