Show simple item record

contributor authorJ. Hedrick
contributor authorL. Beholz
contributor authorAli R. Zand
contributor authorK. J. Berry
contributor authorSusanta K. Das
contributor authorPanini Kolavennu
date accessioned2017-05-09T00:33:31Z
date available2017-05-09T00:33:31Z
date copyrightFebruary, 2009
date issued2009
identifier issn2381-6872
identifier otherJFCSAU-28936#011021_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/140904
description abstractA new proton exchange membrane (PEM) has been fabricated using a novel patented polymer structure modification technology. It has been shown that the new membrane has a higher proton transfer rate and lower resistance as compared to Nafion® . This paper discusses issues related to membrane fabrication and testing procedures. (i) A brief fabrication procedure of PEM is outlined. The fabrication technique used here separates the proton exchange and structural requirements of the PEM allowing greater flexibility in membrane design. The proton exchange material developed herein is a terpolymer composed of various ratios of acrylic acid, styrene, and vinylsulfonic acid. Following a patented polymer structure modification technology, these materials were bound to an ethylene-tetrafluoroethylene copolymer mesh that had been rendered adhesive by hydroxylation in a two-step water-borne process. (ii) A previously developed theoretical model is used to calculate the relative resistance and proton transfer rate. According to the model, a simple second order differential equation describes the entire process and established a relationship between the membrane resistance and the total time taken for a specific amount of protons to pass through it. Finally, (iii) a simple two-cell experimental procedure is developed to calculate the relative membrane resistance and proton transfer capacity. The results show that theoretical predictions are in excellent agreement with the experimental observations. The new membrane could transfer protons approximately 80% faster than Nafion® per unit area under the test conditions utilized. Membrane resistance is also 71% lower compared to Nafion® . These results suggest that there is now a new route of fabricating cost effective proton exchange membranes for fuel cell applications wherein one may focus more on the proton exchange capacity of the membrane allowing the structural properties of the membrane to be considered separately.
publisherThe American Society of Mechanical Engineers (ASME)
titleSynthesis and Characterization of a Composite Membrane for Polymer Electrolyte Fuel Cell
typeJournal Paper
journal volume6
journal issue1
journal titleJournal of Fuel Cell Science and Technology
identifier doi10.1115/1.2971198
journal fristpage11021
identifier eissn2381-6910
keywordsProtons
keywordsMembranes
keywordsElectrical resistance
keywordsPolymers
keywordsWater
keywordsProton exchange membranes
keywordsManufacturing AND Fuel cells
treeJournal of Fuel Cell Science and Technology:;2009:;volume( 006 ):;issue: 001
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record