Show simple item record

contributor authorMatteo Galli
contributor authorJolanta Janczak-Rusch
contributor authorGerd Maier
contributor authorUdo Welzel
contributor authorJohn Botsis
date accessioned2017-05-09T00:32:56Z
date available2017-05-09T00:32:56Z
date copyrightApril, 2009
date issued2009
identifier issn0094-4289
identifier otherJEMTA8-27117#021004_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/140605
description abstractResidual stress relief in ceramic-metal joints produced by active brazing depends primarily on the plastic response of the filler metal. A procedure for the production and mechanical characterization of bulk active filler alloy specimens is developed. In parallel ceramic-metal joints are produced and tested. Residual stresses are measured by X-ray diffraction while the joint strength is assessed by four-point bend tests. The obtained elastoplastic properties of the filler are introduced into finite element models to predict the residual stresses in the joints and their behavior in bending. The results of the simulations show good agreement both with the residual stress measurements and with the results of four-point bend tests.
publisherThe American Society of Mechanical Engineers (ASME)
titleCharacterization of the Residual Stresses and Strength of Ceramic-Metal Braze Joints
typeJournal Paper
journal volume131
journal issue2
journal titleJournal of Engineering Materials and Technology
identifier doi10.1115/1.3078305
journal fristpage21004
identifier eissn1528-8889
keywordsCeramics
keywordsMeasurement
keywordsFillers (Materials)
keywordsResidual stresses
keywordsStress
keywordsBrazing
keywordsMetals AND Alloys
treeJournal of Engineering Materials and Technology:;2009:;volume( 131 ):;issue: 002
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record