Show simple item record

contributor authorJonas P. Gustavsson
contributor authorKyle C. Denning
contributor authorCorin Segal
date accessioned2017-05-09T00:28:20Z
date available2017-05-09T00:28:20Z
date copyrightSeptember, 2008
date issued2008
identifier issn0098-2202
identifier otherJFEGA4-27337#091303_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/138173
description abstractCavitation was studied for a NACA0015 hydrofoil using a material that simulates cryogenic behavior. Several angles of attack and flow speeds up to 8.6m∕s were tested. The material used, 2-trifluoromethyl-1,1,1,2,4,4,5,5,5-nonafluoro-3-pentanone, hereafter referred to as fluoroketone, exhibits a strong thermodynamic effect even under ambient conditions. Static pressures were measured at seven chordwise locations along the centerline of the hydrofoil suction side and on the test section wall immediately upstream of the hydrofoil. Frequency analysis of the test section static pressure showed that the amplitude of the oscillations increased as the tunnel speed increased. A gradual transition corresponding to the Type II-I sheet cavitation transition observed in water was found to occur near σ∕2α=5 with Strouhal numbers based on chord dropping from 0.5 to 0.1 as the cavitation number was reduced. Flash-exposure high-speed imaging showed the cavity covering a larger portion of the chord for a given cavitation number than in cold water. The bubbles appeared significantly smaller in the current study and the pressure data showed increasing rather than constant static pressure in the downstream direction in the cavitating region, in line with observations made in literature for other geometries with fluids exhibiting strong thermodynamic effect.
publisherThe American Society of Mechanical Engineers (ASME)
titleHydrofoil Cavitation Under Strong Thermodynamic Effect
typeJournal Paper
journal volume130
journal issue9
journal titleJournal of Fluids Engineering
identifier doi10.1115/1.2953297
journal fristpage91303
identifier eissn1528-901X
treeJournal of Fluids Engineering:;2008:;volume( 130 ):;issue: 009
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record