Show simple item record

contributor authorXiaojun Yan
contributor authorJingxu Nie
date accessioned2017-05-09T00:27:53Z
date available2017-05-09T00:27:53Z
date copyrightJuly, 2008
date issued2008
identifier issn1528-8919
identifier otherJETPEZ-27026#044501_1.pdf
identifier urihttp://yetl.yabesh.ir/yetl/handle/yetl/137916
description abstractA new experimental method, in which a full scale directionally solidified (DS) alloy turbine blade is loaded by a special design rig employing friction force and heated by eddy current induction, is proposed to conduct creep-fatigue life tests in this investigation. The method can take factors such as geometry, volume, especially cast procedures, etc., into creep-fatigue life assessment. Principle and design of the test rig are fully explained. Creep-fatigue tests of turbine blades made of DZ4 alloy (one type of DS alloys) were conducted and test data were analyzed. Life prediction based on test data of this investigation shows good agreement with actual flight experience of these blades. The method of this article provides a new way to estimate the potential creep-fatigue or low cycle fatigue life for turbine blades.
publisherThe American Society of Mechanical Engineers (ASME)
titleCreep-Fatigue Tests on Full Scale Directionally Solidified Turbine Blades
typeJournal Paper
journal volume130
journal issue4
journal titleJournal of Engineering for Gas Turbines and Power
identifier doi10.1115/1.2901174
journal fristpage44501
identifier eissn0742-4795
keywordsCreep
keywordsFatigue
keywordsStress
keywordsTurbine blades
keywordsBlades AND Temperature
treeJournal of Engineering for Gas Turbines and Power:;2008:;volume( 130 ):;issue: 004
contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record